+- Free Academic Seminars And Projects Reports (https://easyreport.in)
+-- Forum: Seminars Topics And Discussions (https://easyreport.in/forumdisplay.php?fid=30)
+--- Forum: Engineering Seminars Topics (https://easyreport.in/forumdisplay.php?fid=7)
+---- Forum: Seminar Requests (https://easyreport.in/forumdisplay.php?fid=29)
+---- Thread: density based traffic control system using ir sensors ppt download (/showthread.php?tid=21769)
density based traffic control system using ir sensors ppt download - nitin - 08-16-2017
density based traffic control system using ir sensors ppt download
Abstract
Nowadays, controlling the traffic becomes major issue because of rapid increase in automobiles and also because of large time delays between traffic lights. So, in order to rectify this problem, we will go for density based traffic lights system. This article explains you how to control the traffic based on density.In this system, we will use IR sensors to measure the traffic density. We have to arrange one IR sensor for each road; these sensors always sense the traffic on that particular road. All these sensors are interfaced to the microcontroller. Based on these sensors, controller detects the traffic and controls the traffic system.
Introduction
The main heart of this traffic system is microcontroller. IR sensors are connected to the PORT C (PC0, PC1, PC2, and PC3) of the microcontroller and traffic lights are connected to PORT B and PORT D. If there is a traffic on road then that particular sensor output becomes logic 0 otherwise logic 1. By receiving these IR sensor outputs, we have to write the program to control the traffic system.
Circuit Components:
ATmega8 controller
PCB board
IR sensors -4
LED s-12(4-red,4-green,4-yellow)
12v Battery or adaptor
Serial cable
Connecting wires
Density Based Traffic Light Control System Circuit Design:
This circuit consists of 4 IR sensors, atmega8 microcontroller, 4 traffic lights.
IR transmitter looks like an LED. This IR transmitter always emits IR rays from it. The operating voltage of this IR transmitter is 2 to 3v. These IR (infra red) rays are invisible to the human eye. But we can view these IR rays through camera.
IR receiver receives IR rays that are transmitted by IR transmitter. Normally IR receiver has high resistance in order of mega ohms, when it is receiving IR rays the resistance is very low. The operating voltage of IR receiver also 2 to 3V.
density based traffic control system using ir sensors ppt download - selman_999 - 08-16-2017
Nowadays, controlling the traffic becomes major issue because of rapid increase in automobiles and also because of large time delays between traffic lights. So, in order to rectify this problem, we will go for density based traffic lights system. This article explains you how to control the traffic based on density.
In this system, we will use IR sensors to measure the traffic density. We have to arrange one IR sensor for each road; these sensors always sense the traffic on that particular road. All these sensors are interfaced to the microcontroller. Based on these sensors, controller detects the traffic and controls the traffic system.
Density Based Traffic Signal System Circuit Principle:
The main heart of this traffic system is microcontroller. IR sensors are connected to the PORT C (PC0, PC1, PC2, and PC3) of the microcontroller and traffic lights are connected to PORT B and PORT D. If there is a traffic on road then that particular sensor output becomes logic 0 otherwise logic 1. By receiving these IR sensor outputs, we have to write the program to control the traffic system.
density based traffic control system using ir sensors ppt download - karthi - 08-16-2017
[size=medium[/size]
DENSITY BASED TRAFFIC LIGHTS CONTROL SYSTEM USING IR SENSORS