Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Internet Protocol full report
#1

Internet Protocol


Definition:
IP (Internet Protocol) is the primary network protocol used on the Internet, developed in the 1970s. On the Internet and many other networks, IP is often used together with the Transport Control Protocol (TCP) and referred to interchangeably as TCP/IP.
IP supports unique addressing for computers on a network. Most networks use the Internet Protocol version 4 (IPv4) standards that features IP addresses four bytes (32 bits) in length. The newer Internet Protocol version 6 (IPv6) standard features addresses 16 bytes (128 bits) in length.
Internet Protocol version 4 (IPv4) is the fourth revision in the development of the Internet Protocol (IP) and the first version of the protocol to be widely deployed. IPv4 is still by far the most widely deployed Internet Layer protocol (As IPv6 deployment is still in its infancy)

Addressing

IPv4 uses 32-bit (four-byte) addresses, which limits the address space to 4294967296 (232) addresses. Addresses were assigned to users, and the number of unassigned addresses decreased. IPv4 address exhaustion occurred on February 3, 2011. It had been significantly delayed by address changes such as classful network design, Classless Inter-Domain Routing, and network address translation (NAT).

Allocation

Originally, an IP address was divided into two parts: the network identifier was the most significant (highest order) octet of the address, and the host identifier was the rest of the address. The latter was therefore also called the rest field. This enabled the creation of a maximum of 256 networks. This was quickly found to be inadequate.
To overcome this limit, the high order octet of the addresses was redefined to create a set of classes of networks, in a system which later became known as classful networking.
The system defined five classes, Class A, B, C, D, and E. The Classes A, B, and C had different bit lengths for the new network identification. The rest of an address was used as previously to identify a host within a network, which meant that each network class had a different capacity to address hosts. Class D was allocated for multicast addressing and Class E was reserved for future applications.
Reply



Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2024 iAndrew & Melroy van den Berg.