08-16-2017, 10:37 PM
Done by:
Ahmed Sudqi Hussein Abdul-Rahman
Ahmad Nasr Raja Mohammad
Supervised by:
Prof. Nihad Dib
Abstract
This report presents the design, implementation, and testing of a dual-band cell-phone jammer. This jammer works at GSM 900 and GSM 1800 simultaneously and thus jams the three well-known carriers in Jordan (Zain, Orange, and Umniah). This project went through two phases:
Phase one: studying the GSM-system to find the best jamming technique, establishing the system design and selecting suitable components.
Phase two: buying all the needed components, drawing the overall schematics, fabricating the PCB layout, assembling the devices, performing some measurements and finally testing the mobile jammer.
The designed jammer was successful in jamming the three carriers in Jordan as will be shown at the end of this report.
Introduction
Communication jamming devices were first developed and used by military. This interest comes from the fundamental objective of denying the successful transport of information from the sender (tactical commanders) to the receiver (the army personnel), and vice-versa. Nowadays, mobile (or cell) phones are becoming essential tools in our daily life. Here in Jordan, for example, with a rather low population (around 5 million), three main cell phone carries are available; namely; Zain, Orange, and Umniah The first two use the GSM 900 system, while the third uses the GSM 1800 system. Needless to say, the wide use of mobile phones could create some problems as the sound of ringing becomes annoying or disrupting. This could happen in some places like conference rooms, law courts, libraries, lecture rooms and mosques. One way to stop these disrupting ringings is to install a device in such places which will inhibit the use of mobiles, i.e., make them obsolete. Such a device is known as cell phone jammer or "GSM jammer", which is basically some kind of electronic countermeasure device. The technology behind cell phone jamming is very simple. The jamming device broadcasts an RF signal in the frequency range reserved for cell phones that interferes with the cell phone signal, which results in a "no network available" display on the cell phone screen. All phones within the effective radius of the jammer are silenced. It should be mentioned that cell phone jammers are illegal devices in most countries. According to the Federal Communications Commission (FCC) in the USA: "The manufacture, importation, sale, or offer for sale, of devices designed to block or jam wireless transmissions is prohibited". However, recently, there has been an increasing demand for portable cell phone jammers. We should mention that this project, presented in this report, is solely done for educational purposes. There is no intention to manufacture or sell such devices in Jordan, or elsewhere. In this project, a device that will jam both GSM 900 and GSM 1800 services will be designed, built, and tested.
Jamming Techniques
There are several ways to jam an RF device. The three most common techniques can be categorized as follows:
1. Spoofing
In this kind of jamming, the device forces the mobile to turn off itself. This type is very difficult to be implemented since the jamming device first detects any mobile phone in a specific area, then the device sends the signal to disable the mobile phone. Some types of this technique can detect if a nearby mobile phone is there and sends a message to tell the user to switch the phone to the silent mode (Intelligent Beacon Disablers).
2. Shielding Attacks
This is known as TEMPEST or EMF shielding. This kind requires closing an area in a faraday cage so that any device inside this cage can not transmit or receive RF signal from outside of the cage. This area can be as large as buildings, for example.
3. Denial of Service
This technique is referred to DOS. In this technique, the device transmits a noise signal at the same operating frequency of the mobile phone in order to decrease the signal-to-noise ratio (SNR) of the mobile under its minimum value. This kind of jamming technique is the simplest one since the device is always on. Our device is of this type.
for more:
http://docs.googleviewer?a=v&q=cache:Ffn...st.edu.jo/ nihad/files/mat/591/Jammer%2520Final%2520Report.pdf+Dual+Band+Mobile+Jammer+for+GSM+900+%26+GSM+1800+pdf&hl=en&gl=in&pid=bl&srcid=ADGEESiSr5igbwmbp-2Aa8itrLcL-xL7FJBAo-PPCdRzBjGv-ozbmzr2ftnkMHFFfl4tNM57dhTx8sPSg6c2UZwzG0H4EUM3cN3PRHMEkqfgx7PyRwVz7RBjvqm0o-ebv7EXQVr0jm3T&sig=AHIEtbTl0SUtJE673_51brQ4a89RdyNd5g