08-16-2017, 10:53 PM
recron 3s fibre advantages pdf
Recron 3s, the New Generation "Secondary Reinforcement" for Construction Industry.
Today, concrete is used in a variety of innovative designs because of its many valuable properties such as high compressive strength, stiffness, low thermal and electrical conductivity and low combustibility and toxicity. However, concrete is also known to be brittle and weak in tension and develops cracks during curing, due to thermal expansion and contraction over a period of time.
The recent development of Secondary reinforcement in Concrete in various fields has provided a strong technical base for improving these deficiencies.
Reliance brings you the cutting edge technology via Recron 3s, a speciality secondary reinforcement material developed after extensive research at Reliance Technology Centre.
Applications:
Recron 3S has a wide number of applications in the construction industry.
1. Concrete: Floor, slab, beam, piles, retaining walls, lintel, road, bridges, airport runways etc.
Advantages:
Improves homogeneity of the concrete by reducing segregation of aggregates.
Reduces shrinkage cracks/micro cracks
Increases abrasion resistance by more than 25%.
Increases impact and shatter resistance by 100%
Increases ductility, compressive, flexural and tensile strength
Reduces water permeability which helps prevent correction of primary steel
Increases energy absorption capability of concrete
Replaces or reduces non-structural steel in floors, roads and pavement i.e. slab on grade helps increases joint spacing.
2. PLASTER: Internal Plaster, External Plaster, Gunnite, Shot Crete, Decorative precast Panel
Advantage:
Reduces re-bond loss by 50%-70%
Checks dampness, saves on repainting cost
Improved shatter resistance in walls.
Checks cracks propagation while cutting groves for conduit laying
3. PLASTER OF PARIS(POP):
Advantage:
Checks rebound loss, reduces cracks, speeds up work and gives a nice look to the wall
4. PRE-CAST MATERIAL: Blocks, pavers, tiles, pipe and railway sleepers
Advantage:
Low curing time promotes high productivity
Reduced breakage during production / transits and placement improves resistance to abrasion shatter and impact
Specifications
Cut length: 3mm, 4.8mm, 6mm or 12mm.
Shape of Recron 3S: Scientifically designed for improved holding of cement and aggregates.
Melting point: >250 degree centigrade.