Design a pressure vessel

[ajeesh]

Hi friends,

I'm doing a "student project" on designing a high temperature pressure vessel with required piping and supporting structures, using ASME Boiler and Pressure Vessel Code, Section VII.

316L Stainless Steel is to be used for this design.

Design parameters are as follows

Diameter 3 feet
Height 5 feet
Max. Design temperature 900 C
Max. Design pressure 2 bar

Can somebody please help me with these calculations? I would appreciate it a lot.

Thanks

[clibinspet]

Hi, thanks for replying on my project request. But my project is based on high temperature application with using 316L stainless steel (non corrosive sheet metal / No need of corrosion allowance) . Unfortunately the project design given here is based on low temperature with using of corrosive sheet metal (where a corrosion allowance is needed). Do you have any ability to help me with my particular calculations? I just need these calculations and not any other back ground details because I just have to print this project on 25 papers (A4)(including drawings and all that) so just precise calculations would be enough.

[nirajtevar88]

to get information about the topic " Design a pressure vessel " full report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-desig...ull-report

http://seminarsprojects.net/Thread-desig...ure-vessel

http://seminarsprojects.net/Thread-desig...ure-vessel

[slacker]

to get information about the topic " Design a pressure vessel " full report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-desig...ull-report

http://seminarsprojects.net/Thread-desig...ure-vessel

http://seminarsprojects.net/Thread-desig...ure-vessel