08-17-2017, 12:40 AM
chopper fed dc motor drive
[attachment=674]
INTRODUCTION
Development of high performance motor drives are very essential for industrial applications. A high performance motor drive system must have good dynamic speed command tracking and load regulating response. DC motors provide excellent control of speed for acceleration and deceleration. The power supply of a DC motor connects directly to the field of the motor which allows for precise voltage control, and is necessary for speed and torque control applications.
DC CHOPPER
A chopper is a static power electronic device that converts fixed dc input voltage to a variable dc output voltage. A Chopper may be considered as dc equivalent of an ac transformer since they behave in an identical manner. As chopper involves one stage conversion, these are more efficient [2].
Choppers are now being used all over the world for rapid transit systems. These are also used in trolley cars, marine hoist, forklift trucks and mine haulers. The future electric automobiles are likely to use choppers for their speed control and braking. Chopper systems offer smooth control, high efficiency, faster response and regeneration facility [2].
PRINCIPLE OF CHOPPER OPERATION
A chopper is a high speed on" or off semiconductor switch. It connects source to load and load and disconnect the load from source at a fast speed. In this manner, a chopped load voltage as shown in Fig. is obtained from a constant dc supply of magnitude Vs. For the sake of highlighting the principle of chopper operation, the circuitry used for controlling the on, off periods is not shown. During the period Ton, chopper is on and load voltage is equal to source voltage Vs. During the period Toff, chopper is off, load voltage is zero. In this
manner, a chopped dc voltage is produced at the load terminals [2].
CURRENT- LIMIT CONTROL
In this control strategy, the on and off of chopper circuit is decided by the previous set value of load current. The two set values are maximum load current and minimum load current.
When the load current reaches the upper limit, chopper is switched off. When the load current falls below lower limit, the chopper is switched on. Switching frequency of chopper can be controlled by setting maximum and minimum level of current.
Current limit control involves feedback loop, the trigger circuit for the chopper is therefore more complex.PWM technique is the commonly chosen control strategy for the power control in chopper circuit.