10-06-2017, 07:10 AM
Hello friends, After such a long break, I want to share a Matlab/Simulink model which I made for simulating 9 level cascaded multilevel inverter as mentioned in the title of this post. To be precise, this post deals with Single Phase Multilevel Inverter.
Usually the objective of multilevel inverter designers is to get a purely sinusoidal wave out of a Constant or variable DC Voltage source or current source. The inverters using DC Voltage Source are called VSI i.e. Voltage Source Inverters while the inverters made using Current source are called CSI i.e. Current Source Inverter. The circuit for both the types of inverters are basically same. Only difference is the presence of an extra inductor present in CSI.
In this post, I want to discuss only about Voltage Source Inverter (VSI). Using VSI, we can obtain a square wave output of 1 level or we can obtain an output of upto 2 level by making the changes in switch firing delay.
But if we want to get a purely sinusoidal wave, then it s difficult (or probably impossible) with simple H-bridge based single phase inverter. For this reason, we use the concepts of multilevel inverters wherein the whole inverter system combined together will give an output in the form of steps which looks similar to sine wave inverters. Using large number of levels, by adjusting the delays and at the end by using a proper capacitor, we can get a purely sinusoidal wave.
As per my knowledge APC Inverters by Schneider Electric , is one of the best inverter which produces a purely sinusoidal waveform.
Basically there are 3 topology of Multilevel Inverters
1. Diode Clamped Multilevel Inverters
2. Flying Capacitors Multilevel Inverters
3. Cascade Multilevel Inverters
In my model, I have used the Cascaded multilevel Inverter topology which is far better than others when cost of implementation is concerned. Using this topology, we can obtain n level using (n-1) H-bridges, with each bridge consisting of 4 switches like MOSFET, IGBT, etc.
Here, I have used 8 H-bridges Single phase Inverters and connected them in series. By varying the switching timing in the pulse generator block, I obtained 9 levels or steps in the output.
