project report on simulator 8085 build in java
complete easy to use gui formate ....etc

[:=Read Full Message Here=:]

i need to store real time values of an circuit output which varies from 5v to 24 v in a micro controller 8051 but my prob is as micro controller takes only digital values i need to use an ADC to convert but the limitation of ADC s 5v what can i do to capture the real time values. ....etc

[:=Read Full Message Here=:]

I am designing an AM receiver with these components, active antenna,RF amplifier, BP filter ADC,Microprocessor(8051), DAC, audio amplifier and a speaker. the DSP part is really challenging me.I am aiming at using FIR filter, a program to processed by 8051 being interfaced by adc and dac! Any help is highly welcome! ....etc

[:=Read Full Message Here=:]

Elevator function is to be shown using LEDs and switch corresponding to each floor.
Functioning is as follows:
1. There are 4 levels(floors) and corresponding to each level an LED and a switch is provided. Also, there are two separate LEDs which indicate whether the lift is going up or down.
2. Initially, the lift is at ground floor (reference level). When a request is made by a user from other floor, say 2nd floor, lift moves to that floor and movement of lift is shown by turning on LEDs of floors as it crosses the respective floor and then ....etc

[:=Read Full Message Here=:]

ABSTRACT

A pipelined analog-to-digital converter (ADC) architecture suitable for high-speed (150 MHz), Nyquist-rate A/D conversion is presented. At the input of the converter, two parallel track-and-hold circuits are used to separately drive the sub-ADC of a 2.8-b first pipeline stage and the input to two time-interleaved residue generation paths. Beyond the first pipeline stage, each residue path includes a cascade of two 1.5-b pipeline stages followed by a 4-b backend folding ADC. The full-scale residue range at the output of the pipeline ....etc

[:=Read Full Message Here=:]

i am doing project based on the microcontroller .. am giving analog output from sensor to the adc and from ADC am connecting to microcontroller so ....etc

[:=Read Full Message Here=:]

To get full information or details of adc and dac interfacing with 8085 lecture notes pdf please have a look on the pages

https://scribddoc/46940503/Microprocessor-Lab-Manual-Final

if you again feel trouble on adc and dac interfacing with 8085 lecture notes pdf please reply in that page and ask specific fields in adc and dac interfacing with 8085 lecture notes pdf ....etc

[:=Read Full Message Here=:]

detail information on interfacing of lm35,adc 0808 and ic555 for temperature sensor on [email protected] ....etc

[:=Read Full Message Here=:]

introduction
Digital thermometer is a good choice for beginners who just left the world of microcontrollers, because it provides an opportunity to learn using sensors to measure real world signals are analog in nature is. This article describes the project as based on microcontroller and temperature sensor LM35 PIC16F688. Is analogous to the LM35 sensor that converts the temperature to a proportional analog voltage. The output signal from the sensor is connected to one of the inputs of the ADC in a PIC16F688 microcontroller to obtain an equival ....etc

[:=Read Full Message Here=:]

Design of ADC/DAC card and Interfacing With 8085 Microprocessor

Submitted By:
Pulkit Jain
Prateek Bhansali
Rocky Gupta




Abstract:
In this project we attempt to design a simple ADC/DAC card which can be easily interfaced with 8085 microprocessor kit for Data Acquisition(DAQ) purposes. We extent our work by designing a pcb

APPLICATION:
Commerical ADC/DAC cards can cost hundreds of dollars, not viable for teaching purposes. This ADC/DAC card, which is much cheaper can be used ....etc

[:=Read Full Message Here=:]