Asynchronous Transfer Mode
Presented by

Ambily
Lavanya
Meghana
What is ATM
Asynchronous Transfer Mode (ATM), a dedicated connection switching technology, uses digital signal technology that divides upper-level data (digital data) into 53 byte cell units and to transmit on a physical medium.
A cell is individually asynchronously processed relative to other cells .
It operates independently of the type of transmission being generated at the upper layers and of the type of the physical laye ....etc

[:=Read Full Message Here=:]

pls send the ppt of dynamic synchronous transfer mode ....etc

[:=Read Full Message Here=:]

i need a dynamic transfer mode seminar ppt and report
please help me by giving the dynamic transfer modes seminar reports and the ppt. ....etc

[:=Read Full Message Here=:]

to get information about the topic Asynchronus transfer mode full report ,ppt and related topic refer the page link bellow
http://seminarsprojects.net/Thread-asynchronous-transfer-mode

http://seminarsprojects.net/Thread-asynchronous-transfer-mode-atm

http://seminarsprojects.net/Thread-asynchronous-transfer-mode--3214 ....etc

[:=Read Full Message Here=:]

A SEMINAR REPORT ON
ASYNCHRONOUS TRANSFER MODE(ATM)

INTRODUCTION
High performance, cell-oriented switching and multiplexing technology

Utilizes fixed-length packets to carry different types of traffic

Helps in efficient multimedia applications, high-speed LAN connections and used in broad range of networking

devices
OVERVIEW
BENEFITS OF ATM
high performance via hardware switching
dynamic bandwidth for bursty traffic
class-of-service support for multimedia
scalability in speed and network size ....etc

[:=Read Full Message Here=:]

For the purposes of the present document, the following terms and definitions apply:
Access token:- right to use a slot for transmitting data on a physical interface for a certain number of bypass hops
Address, DTM address:- 64 bit numerical value that uniquely identifies a node in a DTM network
Allocation domain:- same as a bypass chain where, if the topology is point-to-point or bus, the last node is not counted as member of the AD.

Bypass Chain (BC):- series of concatenated physical links, where data can be transported end-to-end usin ....etc

[:=Read Full Message Here=:]

Am rema,want to know about an efficient common mode hybrid filter used in SMPS for my seminar work.

Abstract obtained from IEE is After the study of electromagnetic interference (EMI)
mechanisms in switching mode power system (SMPS) and the soft
switch, this paper proposes a novel hybrid filter (HEF) to suppress
commend mode EMI in SMPS. The HEF consists of a passive filter
and an active filter. Matching network, which can reduce
impedance mismatching effects, is introduced in passive part. A
feed-forward active filter is adopted ....etc

[:=Read Full Message Here=:]

i want coordinated master control project i.e.,boiler follow mode and turbine follow mode
i have doubt this project o help me .. ....etc

[:=Read Full Message Here=:]

to get information about the topic dynamic synchronous transfer modefull report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-dynamic-synchronous-transfer-mode?pid=676&mode=threaded

http://seminarsprojects.net/Thread-dynamic-synchronous-transfer-mode ....etc

[:=Read Full Message Here=:]

ppt on dynamic synchronous transfer mode

DTM is a form of circuit switching for fiber-optic networks that employs TDM (time division multiplexing) in a new way that dynamically reallocates available bandwidth to users that need it. DTM was designed to remove the bottleneck at fiber network access points. These bottlenecks are typically caused by the need to process and buffer large amounts packet-based data. DTM seeks to limit complexity and use transmission capacity more efficiently. In particular, DTM can fully support high-bit-rate, real-ti ....etc

[:=Read Full Message Here=:]