Introduction
Rapid Flow has designed and manufactured the highest quality machines for tube industry since 1979. Rapid machines have earned a good reputation worldwide. Rapid Tube bending machines can be used for economical, small batch to high volume mass production. The range includes Electrical & PLC (Single Axis) Tube Bending Machines. The machine has all production related features. We also supply tooling for the simple to most complex tube bending applications.
Features of Pipe Bending Machine
Cost effective & alternative to CNC bending.
....etc

[:=Read Full Message Here=:]

I required saddle support design calculation pdf



i need design calculations for hydraulic service jack almost all component to check my work ....etc

[:=Read Full Message Here=:]

Request for free demineralisation process design calculation like resin volume, free board height, vessel dia, operating exchange capacity, regeneration level etc;. ....etc

[:=Read Full Message Here=:]

pendulum hand water pump design calculation

Hand water pump with a pendulum is a very simple solution for pumping water. It provides alleviation of work, because it is enough to move the pendulum occasionally with a little finger to pump the water, instead of large swings. Work is alleviated because easier, long-lasting and effortless use of the hand water pump has been enabled.

Input energy for starting the process of pumping, in form of occasional pushing of the pendulum, is much less than with typical hand pumps. Whereas typical hand pumps ....etc

[:=Read Full Message Here=:]

The goal of this project is to create a model of bench vice which is pneumatically operated. Using air pressure to create mechanical motion in the spindle of the vice provides a safe & efficient way to reduce human effort.
The mechanical motion in the spindle is created with the help of a double actuating cylinder which is operated by a 5/2 pilot valve & two 3/2 push buttons with the help of the air hoses. ....etc

[:=Read Full Message Here=:]

Dear Sir

Kindly provide quotation & size for sewage treatment plant for our primary school building (ground floor only) with 80 students and 20 staff members.

Thanks & Regards

Tanya Pahwa ....etc

[:=Read Full Message Here=:]

Cylinder Blind End Area (in square inches):

PI x (Cylinder Radius)2

Example: What is the area of a 6 diameter cylinder?

Diameter = 6
Radius is 1/2 of diameter = 3
Radius2 = 3 x 3 = 9

x (Cylinder Radius)2 = 3.14 x (3)2 = 3.14 x 9 = 28.26 square inches



Cylinder Rod End Area (in square inches):

Blind End Area - Rod Area

Example: What is the rod end area of a 6 diameter cylinder which has a 3 diameter rod?

Cylinder Blind End Area = 28.26 square inches
Rod Diameter = 3
Radius is 1/2 of rod diameter = 1.5
Radius2 = 1.5 x 1.5 ....etc

[:=Read Full Message Here=:]

Hello sir, Please give me detail information on :
1) the detail procedure with what are different parameters are used.
2) the reagents and operating conditions.
3) the yield and cost per ton for product. ....etc

[:=Read Full Message Here=:]

graduated leaf spring design calculations to my email id [email protected] ....etc

[:=Read Full Message Here=:]

design calculation of hydraulic lift pdf

Abstract

The following paper describes the design as well as analysis of a hydraulic scissor lift. Conventionally a scissor lift or jack is used for lifting a vehicle to change a tire, to gain access to go to the underside of the vehicle, to lift the body to appreciable height, and many other applications Also such lifts can be used for various purposes like maintenance and many material handling operations. It can be of mechanical, pneumatic or hydraulic type. The design described in the paper is dev ....etc

[:=Read Full Message Here=:]