i want to interface r303 with lpc2148 but can't do it please send me the code to interface it as soon as possible ....etc

[:=Read Full Message Here=:]

greetings sir,
i have tarang f4 module and i need to know the software for serial communication and pin assign.please help me to know..thankyou ....etc

[:=Read Full Message Here=:]

Features and Benefits:

Point to point, point to multi point, Mesh and peer-to-peer topologies on proprietary stack.
Direct Sequence Spread Spectrum technology.
Each direct sequence channel has 64K unique network addresses.
Transmit Power: 0 dBm.
RF data rate: 250 kbps.
Acknowledgement mode communication with retries.
Power saving modes.
Source / destination addressing.
Unicast and broadcast communication.
Analog to digital conversion and digital I/O line support.
Default configuration for ready to use. ....etc

[:=Read Full Message Here=:]

I need to send and receive data from my laptop to other by using tarang f4 wireless module. Is any source code available for it if so Can you send me ..?? ....etc

[:=Read Full Message Here=:]

module MM42(A1,A2,B1,B2,N,S1,S2,clk);
input clk;
input A1,A2,B1,B2,N;
output S1,S2;
reg a1,a2,b1,b2,n,bd1,bd2,d1,d2,w,y;
reg s1,s2,s11,s21,s12,s22;
reg q,A,Ai1,Ai2,qi1,qi2,mbrfa_ctemp,bypass;
reg temp1,temp2;
integer i=0;
initial
begin
assign q=1'h0;
assign A=1'h0;
assign s1=7'h0;
assign s2=7'h0;
assign bd1=(B1<<1)^(B2<<1);
assign bd2=(B1<<1)&(B2<<1);
assign d1=bd1^bd2^n;
assign d2=bd1&bd2&n;
assign mbrfa_ctemp=1'h0;
assign bypass=1'h0;
assign qi1=1'h0;
assign qi2=1'h0;
assign s11=7'h0;
assign s21=7'h0;
assign s12=7'h0;
assi ....etc

[:=Read Full Message Here=:]

how data to be transmitted using tarang f4 zigbee module and also i want command to send the data through zigbee module ....etc

[:=Read Full Message Here=:]

EM-18 RFID reader module is the most commonly used module for radio-frequency identification projects. It offers low cost, small size, low power consumption and easy to use. It can be directly connected to micro-controllers using UART communication. UART software can be used for micro-controllers that do not have UART modules. In this tutorial we will see how to connect the RFID reader module EM-18 with the micro-controller PIC 16F877A. By understanding the basic idea, you will be able to interface with any micro-controller.

RFID work ....etc

[:=Read Full Message Here=:]

i am going to make fingerprint attendence marking, so i have need of sm630 module code.
so quickly send me.
thanks for this.. ....etc

[:=Read Full Message Here=:]

How to reset the TARANG F4 module in the process of configuration. ....etc

[:=Read Full Message Here=:]

sir please send me information about the tarang f4

am doing on my main project on tarangf4..
in railways station

please send to my email address..

[email protected] ....etc

[:=Read Full Message Here=:]