PLCC.



Outdoor equipment:-

1. Wave trap:- These are used for blocking the HF signals of PLCC entering into substation. Wave traps will allow only high voltage power signal of 50Hz frequency.

2. Line matching (LMU):- The output of PLCC is connected to the LMU then to the power lines to achieve proper impedance matching between PLCC equipment and power lines.

3. Capacitance voltage transformer/Capacitor coupling (CVT/CC):-
(CVT/CC) is connected betwe ....etc

[:=Read Full Message Here=:]

What is the role of CVT in PLCC.Kindly explain through Circuit diagram. ....etc

[:=Read Full Message Here=:]

To get full information or details of baja cvt transmission calculation please have a look on the pages

http://seminarsprojects.net/Thread-continuously-variable-transmission-cvt-seminar-report?pid=7261&mode=threaded

http://seminarsprojects.net/Thread-continuously-variable-transmission-cvt-seminar-report?pid=33679&mode=threaded

http://seminarsprojects.net/Thread-continuously-variable-transmission-cvt-seminar-report

http://seminarsprojects.net/Thread-continuously-variable-transmission-cvt-seminar-report?pid=45776&mode=threaded

http://seminar ....etc

[:=Read Full Message Here=:]

pls provide me the working of phase to ground coupling and phase to phase coupling coupling in PLCC. ....etc

[:=Read Full Message Here=:]

PLCC OVERVIEW :

PRESENTED BY BIMAL NANDA


PLCC Technology

PLCC system uses the same High Voltage transmission line connecting two sub-stations for telecommunication purpose too.
PLCC is used in all power utilities as a primary communication service to transmit speech, telemetry and protection tripping commands. This is economic and reliable for inter grid message transfer as well as low bit rate RTU signals.
The voice/data are mixed with radio frequency carrier (40-500kHz), amplified t ....etc

[:=Read Full Message Here=:]

You Can use honda Activa CVT but you will face following issues-

1. There will be coupling issue. You cannot couple a CVT with any engine. you.If you are using different engine you will have to design a coupler. same will happen with final drive. This is a difficult task, and cause lot of problem for first timer.

2. Before moving ahead make sure you will get the Ratio you desired. You will lost advantage of CVT if Ratios are not right. ....etc

[:=Read Full Message Here=:]

full ppt seminar report on plcc

Power Line Carrier Communication (PLCC)

Power Line Carrier Communication - PLCC
Power Line Carrier Communication PLCC (photo: Zanith Transformers & Swithgears Pvt. Ltd)
Content

Introduction
Major goal/Application of PLCC
Main Components of PLCC:
Coupling Capacitor
Line trap Unit
Transmitters and Receivers
Hybrids and Filters
Line Tuners
Master Oscillator and Amplifiers
Protection and earthing of coupling equipment
Advantages of Digital PLCC over Analog ones
Typical signal to noise ratio calculation by conside ....etc

[:=Read Full Message Here=:]

I need a full training report on PLCC. Can you help me for this???? ....etc

[:=Read Full Message Here=:]

To get full information or details of plcc sub station please have a look on the pages

http://seminarsprojects.net/Thread-power-line-carrier-communication--14681

if you again feel trouble on plcc sub station please reply in that page and ask specific fields in plcc sub station ....etc

[:=Read Full Message Here=:]

ABSTRACT
This paper deals with the implementation of power line
network in the field of electricity billing. In the present
scenario power line communication (PLC) is one of the
economical ways of communication of data. Even though
there are new methods of wireless communication methods,
practically it is very much time consuming to install such a
system, and also it is highly cost consuming method .But the
power lines which already exist and connect every household
in a particular area is more advantageous as it does not require
any ....etc

[:=Read Full Message Here=:]