I need Programming of this project if possible send me the software recquirements of this project ....etc

[:=Read Full Message Here=:]

Hello Sir

I need help with ppt in this project and steps required to do. I also need help in programming used in this project. if possible sir kindly help me with these things by providing some materials. Will be thankful to u.

Regards
Saurav Bhasker
[email protected] ....etc

[:=Read Full Message Here=:]

To get full information or details of speed control of induction motor using microcontroller please have a look on the pages

http://seminarsprojects.net/Thread-single-phase-ac-motor-speed-control-using-microcontroller-ppt

if you again feel trouble on speed control of induction motor using microcontroller please reply in that page and ask specific fields in speed control of induction motor using microcontroller ....etc

[:=Read Full Message Here=:]

The DC motors are applicable for effective speed control and high starting torque applications like traction, lift, etc. The Pulse Width Modulation twchnique of speed control can be used to obtain a a smooth speed variation without actually taxing in on the high starting torque of the motor. PWM technique also eliminate harmonics. Pulse-width Modulation is achieved with the help of a square wave whose duty cycle is varied to get a varying voltage output. As the average voltage output depends on the duty cycle of the square waveform, the actual ....etc

[:=Read Full Message Here=:]

speed control of dc motor using pic microcontroller with c code

Abstract

This paper is intended to control speed of a DC motor using low cost PIC16F877A microcontroller. To achieve this, PWM technique is used, which is in-built under CCP module of PIC. A PIC based speed control scheme has been developed, in which L293D is used as an interface between motor and microcontroller. The PIC16F877A microcontroller has been programmed to vary the duty cycle of motor using PWM library of MikroC PRO simulation software. The complete simulink model has ....etc

[:=Read Full Message Here=:]

Guided by:
Ms. Monika Sharma

Prepared by:
Akshay Patel
Rohan Shah


Introduction:

A stepper motor (or step motor) is a brushless, synchronous electric motor that can divide a full rotation into a large number of steps.
Stepper motors are similar to switched reluctance motors (which are very large stepping motors with a reduced pole count, and generally are closed-loop commutated.)

Fundamentals of operation

Stepper motors operate differently from DC brush motors, which rotate when voltage ....etc

[:=Read Full Message Here=:]

i want
ppt on dc motor speed control using 8052 microcontroller ....etc

[:=Read Full Message Here=:]

INTRODUCTION
This assignment is basically designed to demonstrate the use of controllers in DC motor which consists of two stage ,electronic stage that is controlled by 8 bit microcontroller and second is the mechanical stage consisting of gear box which controls the motion of DC motor to provide a impulse to electronic stage which generates a resultant signal to control the parameters of controller.
FEEDBACK-CONTROL THEORY
Figure 1 shows the block diagram of a closed-loop system. In this configuration a ....etc

[:=Read Full Message Here=:]

You have knowledge about micro controller but don't know what type of questions recruiter will ask in interviews. Do not get afraid about your interviews, here are the Frequently asked Micro controller questions.

The following questions are frequently asked micro controller topic questions in various interviews.

1. What is meant by micro controller?
Microcontroller is a small chip that has in-build Micro processor, memory, ports, timers and converter. Micro controllers are designed for specific use. For instance, micro controller in TV r ....etc

[:=Read Full Message Here=:]

need ppt on speed control of universal moter by using microcontroller ....etc

[:=Read Full Message Here=:]