i am looking out for can crusher (pneumatic process) related calculations..
So could u please help me out ..do send me in the material related to it as soon as possible..thank you!!
i need the calculations related to (pneumatic process) can crusher.. ....etc

[:=Read Full Message Here=:]

hi
cost sheet format for construction company Guest 0 14 Yesterday 04:25 PM
Last Post: Guest
bank security with automatic voice announcement system project design Guest 1 336 12-06-2013 10:32 AM
Last Post: Guest
project design of mechanical parts ppt ....etc

[:=Read Full Message Here=:]

pl send dense phase & vacuum type conveying in xls

mail id [email protected]

thanks

vikas ....etc

[:=Read Full Message Here=:]

Abstract
Current relationships for determination of the pressure drop with pneumatic conveying of solids in pipes are not of general validity. The theoretical considerations underlying these relationships do not take into account the influence of the rotatory motion of the particles. On the other hand, extremely high rotatory speeds of the particles due to wall collision are observed.
Therefore a new concept is presented which takes into account the rotatory motion of the particles. A further aim was to repr ....etc

[:=Read Full Message Here=:]

please provide me some necessary details about the calculation of slider crank mechanism ....etc

[:=Read Full Message Here=:]

rcc storage tank design for 1000 mt of material storage
material specific gravity is 1600 kg/m3 ....etc

[:=Read Full Message Here=:]

SKYBUS METRO INTRODUCTION
The Skybus project was envisioned while looking at the pathetic roadcondition created by the metro infrastructure put in place on the wide roads whichhas caused enormous hardship and delays, traffic jams for the daily road users. Theconcept of metro as the solution to the city traffic jams as well as to handle large people movement from one area of the city to the other end seems very bright whenlooked upon from the surface level, whereas in reality people who owned the cars aswell as the public transport bus system o ....etc

[:=Read Full Message Here=:]

knuckle joint design and calculations

Knuckle joints may be cast or fabricated or forged. In the knuckle joint illustrated, the rods are integral with the eye and fork (forged construction). However, the knuckle joint is often separate to the rods, and the rods need to be welded or screwed into the eye and fork. In the knuckle joint illustrated, there is no separate bearing and rotational or motion occurs between the pin and eye or pin and fork or both. If there is considerable movement, it may be necessary to use bearings to minimise fricti ....etc

[:=Read Full Message Here=:]

I am looking for pneumatic conveying system software free download ....etc

[:=Read Full Message Here=:]

now i am doing my b.e project on connecting rod and in this i need some data for desining calculation of con rod..
1 allowable tensile stress
2allowable bending stress
3compressive yield strees of material C70S6 ....etc

[:=Read Full Message Here=:]