Doubly-Fed Induction Generator for Variable Speed Wind Energy Conversion Systems- Modeling & Simulation
Abstract The aim of this paper is to present the complete modeling and simulation of wind turbine driven doubly-fed induction generator which feeds ac power to the utility grid. For that, two pulse width modulated voltage source converters are connected back to back between the rotor terminals and utility grid via common dc link. The grid side converter controls the power flow between the DC bus and the AC side and allows the ....etc

[:=Read Full Message Here=:]

DOUBLY FED INDUCTION MACHINE

INTRODUCTION
ELECTRICAL MACHINES
Based on the supply, 2 types-AC machine & DC machine
AC machines are of different types
1. Induction machine
2. Synchronous machine etc.

INDUCTION MACHINE
Induction machines are of different types and one of the type in particular are Singly Fed and Doubly Fed.
SINGLY FED INDUCTION MACHINE
1. Only ONE winding active in ENERGY conversion Process
2. Can have speed around Synchronous Speed.

DOUBLY FED INDUCTION MACHINE
T ....etc

[:=Read Full Message Here=:]

hello,

please provide me the abstract and the full article details..
thanks.. ....etc

[:=Read Full Message Here=:]

difference between chopper fed drives and converter fed drives pdf

If the source of supply is d.c. (for example in a battery vehicle or a rapid transit system) a chopper-type converter is usually employed. The basic operation of a single-switch chopper was discussed in topic 2, where it was shown that the average output voltage could be varied by periodically switching the battery voltage on and of for varying intervals. The principal difference between the thyristor-controlled rectifier and the chopper is that in the former the motor current ....etc

[:=Read Full Message Here=:]

Control Dynamics of a Doubly Fed Induction Generator Under Sub- and Super-Synchronous Modes of Operation


M. Aktarujjaman, Student Member,
IEE, M.E. Haque, Member, IEE, K. M. Muttaqi, Senior
Member, IEE, M. Negnevitsky, Member,
IEE and G. Ledwich, Senior Member, IEE


Abstract-
Abstract
Depending on wind speed, a doubly fed induction generator (DFIG) based variable speed wind turbine is capable of operating in sub- or super-synchronous mode of operation using a back to back PWM converter ....etc

[:=Read Full Message Here=:]

ENHANCED PERFORMANCE OF A DOUBLY FED
WIND-POWER INDUCTION GENERATOR AT WIND-
RANGE BOUNDARIES
ABSTRACT
The doubly fed induction generator (DFIG) is one of the largest generators used
with MW-class wind turbines. This paper focuses on the weak performance areas
of grid-connected DFIG-based wind turbines. Basically, the DFIG performance at
low wind speeds, close to the cut in speed, and around the full rating operation (in
the vicinity of rated wind speed) is investigated. For low wind speed region, the
causes of decreased efficiency ....etc

[:=Read Full Message Here=:]

To get full information or details of doubly feed induction generator please have a look on the pages

http://seminarsprojects.net/Thread-doubly-fed-induction-motor-full-report

if you again feel trouble on doubly feed induction generator please reply in that page and ask specific fields in doubly feed induction generator ....etc

[:=Read Full Message Here=:]

im HUSSAM HAMMADEEN , im a student in Hijjawi faculty for engineering,electrical power engineering ,,
im ask for this project and a simulink part for Doubly Fed Induction Generator Using Back-To-Back PWM Converters and Its Application to Variable Speed Wind-Energy Generation with its mathematical equations and values that make the system stable ..
i do my research for wind speed area less than 6 m/s ,,
i will thanks .. ....etc

[:=Read Full Message Here=:]

Abstract:
This paper deals with the direct torque control of capacitor multilevel VSI actuators. The active control strategy high voltage I high power induction motors fed by floating egy for well-balancing the capacitor voltages is presented highlighting an optimal pattern. The efficiency of this approach is compared to the well-known passive method and it is illustrated by simulation. In the next section, a controlled cycle based algorithm is proposed as an attractive solution for a high performance torque control ....etc

[:=Read Full Message Here=:]

i want exact documentation with base papers on this topic ....etc

[:=Read Full Message Here=:]