The Geneva drive or Maltese cross is a gear mechanism that translates a continuous rotation into an intermittent rotary motion. The rotating drive wheel has a pin that reaches into a slot of the driven wheel advancing it by one step. The drive wheel also has a raised circular blocking disc that locks the driven wheel in position between steps. ....etc

[:=Read Full Message Here=:]

to get information about the topic chain drives related topic refer the page link bellow

http://seminarsprojects.net/Thread-chain-drive-full-presentation?pid=38544&mode=threaded ....etc

[:=Read Full Message Here=:]

To get full information or details of final year project conveyor belt pdf please have a look on the pages

http://seminarsprojects.net/Thread-computerized-conveyor-belt-control

if you again feel trouble on final year project conveyor belt pdf please reply in that page and ask specific fields in final year project conveyor belt pdf ....etc

[:=Read Full Message Here=:]

hi Ashir to get details on fabrication of geneva conveyor please visit following lins where the details added .. if you want more info please reply there /.. http://seminarsprojects.net/Thread-design-and-fabrication-of-geneva-conveyor?page=2
http://seminarsprojects.net/Thread-design-and-manufacturing-of-tilting-conveyor ....etc

[:=Read Full Message Here=:]

i wnt immediately a ppt on ultrasonic spectacles and waist belt for visually impaired and blind persons ....etc

[:=Read Full Message Here=:]

Introduction to Belt drives



Typical belt drives

Two types of belt drives, an open belt drive, (Fig. 13.1.1) and a crossed belt drive (Fig. 13.1.2) are shown. In both the drives, a belt is wrapped around the pulleys. Let us consider the smaller pulley to be the driving pulley. This pulley will transmit motion to the belt and the motion of the belt in turn will give a rotation to the larger driven pulley. In open belt drive system the rotation of both the pulleys is in the same direction, whereas, for cross ....etc

[:=Read Full Message Here=:]

difference between chopper fed drives and converter fed drives pdf

If the source of supply is d.c. (for example in a battery vehicle or a rapid transit system) a chopper-type converter is usually employed. The basic operation of a single-switch chopper was discussed in topic 2, where it was shown that the average output voltage could be varied by periodically switching the battery voltage on and of for varying intervals. The principal difference between the thyristor-controlled rectifier and the chopper is that in the former the motor current ....etc

[:=Read Full Message Here=:]

I need design calculations for 2 mm dia rope drive to lift load of 500N ....etc

[:=Read Full Message Here=:]

to get information about the topic BELT DRIVES full report ,ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-belt-drive ....etc

[:=Read Full Message Here=:]

CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS
INTRODUCTION TO DRIVES

Mechanical components used for power transmission. It may be belt, chain or gear depending on engine design parameters like - Distance between crankshaft and camshaft, engine maximum speed, engine-torque and engine construction cost. - Power transmission is done from one shaft to another shaft which may or may not rotate at same speed.

CHAIN DRIVES ....etc

[:=Read Full Message Here=:]