we are doing project on fabrication of rotary kaller so we need some information about that topic ....etc

[:=Read Full Message Here=:]

quasiturbine rotary air engine seminar powerpoint presentation

The Quasiturbine or Qurbine engine is a proposed pistonless rotary engine using a rhomboidal rotor whose sides are hinged at the vertices. The volume enclosed between the sides of the rotor and the rotor casing provide compression and expansion in a fashion similar to the more familiar Wankel engine, but the hinging at the edges allows the volume ratio to increase. Unlike vane pumps, in which vane extension is generally important and against which the pressure acts to generate the ....etc

[:=Read Full Message Here=:]

State of the Art - Novel InFlow Tech - Featured Project Development; 1-Gearturbine, 2-Imploturbocompressor

1-GEARTURBINE PROJECT
Rotary-Turbo-InFlow Tech

Atypical InFlow Thermodynamic Technology Proposal Submission Novel Fueled Motor Engine Type

*State of the art Innovative concept Top system Higher efficient percent.*Power by bar, for Air-Planes, Sea-Boats, Land-Transport & Dynamic Power-Plant Generation. -Have similar system of the Aeolipile Heron Steam device from Alexa ....etc

[:=Read Full Message Here=:]

Girth gears are large ring gears which are normally fitted to the outside of mills or kilns to provide the primary rotational drive. Used on a number of mining and process applications but are well known in heavy mineral processing such as copper, silver, gold, platinum and iron ore.
Girth Gears
Girth Gears
David Brown girth gears are applied in the mining, cement, minerals industries used in various types of horizontal mills, rotary dryers, rotary kilns and other gear ring applications in heavy processing.
Girth gears are large ring gears ....etc

[:=Read Full Message Here=:]

Hello,
i am in an urgent need of rotary kiln ppr. kindly mail me to [email protected] ....etc

[:=Read Full Message Here=:]

hi faisal firstly u have to specify the gear either spur or helical. eventhough both be gears backlash is measured by the same technique but the difference lies in acceptable backlash. for measuring the backlash u have to keep an equal working surface of both pinion and girth gear. then u can take a feelers gauge and keep the guage in the non working surface at the intermediate place not at the addendum or dedendum.acceptable backlash may be about 10 mm. the new girth gear should be having about 3.8 mm. this backlash varies from kiln to mills. ....etc

[:=Read Full Message Here=:]

send me the ppt presentation of girth gear and its maintainance in rotary kiln and its working in rotary kiln with images and also ppt of rotary kiln size 60mtrs long and 4mtrs oin dia to [email protected] ....etc

[:=Read Full Message Here=:]

synopsis on automatic gear control system and auto gear display ....etc

[:=Read Full Message Here=:]

sir i m interested to learn and see the girth gear alignment of kiln and mill girth gear.





sir i m interested to learn and see the girth gear alignment of kiln and mill girth gear.


....etc

[:=Read Full Message Here=:]

Sir,
Provide the rotary air preheater animation.

Regards,
Mukesh mundiya ....etc

[:=Read Full Message Here=:]