please provide me some necessary details about the calculation of slider crank mechanism ....etc

[:=Read Full Message Here=:]

To get full information or details of scotch yoke mechanism calculations please have a look on the pages

http://scribddoc/151842117/Scotch-Yoke#scribd

if you again feel trouble on scotch yoke mechanism calculations please reply in that page and ask specific fields in scotch yoke mechanism calculations ....etc

[:=Read Full Message Here=:]

The Lenoir cycle is an idealised thermodynamic cycle for the pulse jet engine. An ideal gas undergoes

1. constant volume heating
2. reversible adiabatic expansion.
3. isobaric compression to the volume at the start of the cycle.

The expansion process is isentropic and hence involves no heat interaction. Energy is absorbed as heat during the constant volume process and rejected as heat during the constant pressure process. ....etc

[:=Read Full Message Here=:]

Presented By:
Z. Y. Mijbil1 and M. G. Merdan2
1 Babylon University, College of Veterinary.
2 Babylon University, College of Science, Department of Physics.


Summary
Lattice constant, cohesive energy, direct band gap and valence band width had been calculated for grey tin by using ( CNDO-LUC ) method, then we had been making a comparison with experimental and other workers results for ( C, Si, Ge and Sn ) with zinc-blende structure in order to study the efficiency of this method. The results had show ....etc

[:=Read Full Message Here=:]

What is the raw material and their quantity required in a cupola furnace ....etc

[:=Read Full Message Here=:]

calculations and maths in hawk eye is very good and very useful with a lot of information ....etc

[:=Read Full Message Here=:]

SKYBUS METRO INTRODUCTION
The Skybus project was envisioned while looking at the pathetic roadcondition created by the metro infrastructure put in place on the wide roads whichhas caused enormous hardship and delays, traffic jams for the daily road users. Theconcept of metro as the solution to the city traffic jams as well as to handle large people movement from one area of the city to the other end seems very bright whenlooked upon from the surface level, whereas in reality people who owned the cars aswell as the public transport bus system o ....etc

[:=Read Full Message Here=:]

knuckle joint design and calculations

Knuckle joints may be cast or fabricated or forged. In the knuckle joint illustrated, the rods are integral with the eye and fork (forged construction). However, the knuckle joint is often separate to the rods, and the rods need to be welded or screwed into the eye and fork. In the knuckle joint illustrated, there is no separate bearing and rotational or motion occurs between the pin and eye or pin and fork or both. If there is considerable movement, it may be necessary to use bearings to minimise fricti ....etc

[:=Read Full Message Here=:]

A dog clutch, if successfully implemented in an automatic transmission, provides better packaging and the potential for improved fuel economy. The technical requirements for this concept are examined through modeling and simulation. As a first step, a physics-based component level model is developed that provides an understanding of the basic contact and impact dynamics. The model is compared to a built-in AMESim block to establish confidence. This component level model is then integrated into a powertrain system model within the AMESim environ ....etc

[:=Read Full Message Here=:]

rcc storage tank design for 1000 mt of material storage
material specific gravity is 1600 kg/m3 ....etc

[:=Read Full Message Here=:]