to get information about the topic overload protection transformer by using micro controller full report ppt and related topic refer the page link bellow

http://seminarsprojects.in/showthread.php?mode=linear&tid=38567

http://seminarsprojects.net/Thread-transient-transformer-overload-rating-and-protection

http://seminarsprojects.net/Thread-transformer-protection-using-numerical-relay-full-report

http://seminarsprojects.net/Thread-transformer-overload-alert ....etc

[:=Read Full Message Here=:]

ABSTRACT
LV dc microgrid is used to interconnect distributed resources and sensitive electronic loads. To ensure reliable operation of the LV dc microgrid, it is important to have a well-functioning protection system. When designing an LV dc microgrid protection system, knowledge from existing dc power systems can be used. However, in most cases, these systems use grid-connected rectifiers with current-limiting capability during dc faults. In contrast, an LV dc microgrid must be connected to an ac grid through conver ....etc

[:=Read Full Message Here=:]

To get full information or details of high and low voltage cut off with delay alarm please have a look on the pages

http://iq-technologiesprojects/motor_light/042/

http://electronicshubhigh-low-voltage-cutoff-delay-alarm/

http://circuitstodayhigh-low-voltage-cut-off-with-delay-alarm

http://projectcircuit4u.blogspot2011/08/high-low-voltage-cutoff-with-timer.html

http://eewebproject/sudheer_gupta/high-and-low-voltage-cutoff-with-delay-alarm

http://electronic-circuits-diagramshigh-and-low-voltage-cutout-circuit-with-delay-and-music/

if ....etc

[:=Read Full Message Here=:]

i need the relevant materials with proper description of the title multiple starter with overload and high low voltage protection ....etc

[:=Read Full Message Here=:]

Abstract:
This project(MULTIPLE STARTER WITH OVERLOAD) aims to use the computer keyboard as a dual controller for switching Electrical Motors etc. Also we can monitor the Current for the devices. This project has the provision for setting the current limit also, and the loads will get tripped if the current exceeds the limit. The Actions done can also be Announced by using the computer Multimedia Speaker for e.g. if a motor is switched on/off this is achieved with the use of advanced Transducers and Relays. The is e o/p of the sensors is ....etc

[:=Read Full Message Here=:]

please send about this project to my mail [email protected] ....etc

[:=Read Full Message Here=:]

REGULATED POWER SUPPLY
1.1 Types of Power Supply
There are many types of power supply. Most are designed to convert high voltage AC mains electricity to a suitable low voltage supply for electronic circuits and other devices. A power supply can by broken down into a series of blocks, each of which performs a particular function.
For example a 5V regulated supply:
Figure 1.1 block diagram of a regulated power supply
Each of the blocks is described in more detail:
Transformer- steps down high voltage AC mains ....etc

[:=Read Full Message Here=:]

circuit diagram of over under voltage protectn of electrical applicatins using lm324 ....etc

[:=Read Full Message Here=:]

abstract for short circuit protection dc low voltage system ....etc

[:=Read Full Message Here=:]

A Low-Voltage Low-Power Comparator With
Current-Controlled Dynamically-Biased
Preamplifiers For DCM Buck Regulators

Hoi Lee
Department of Electrical Engineering,
The University of Texas at Dallas,
Richardson, TX 75080-3021, USA.



Abstract-

Comparator-controlled power switch has been widely used to improve power efficiencies of discontinuous-conductionmode (DCM) buck regulators. Some major design challenges are capabilities of the comparator to operate at low voltage and dissipate low power for low-voltage DCM ....etc

[:=Read Full Message Here=:]