Design and Performance of a Gas-Turbine Engine from an Automobile Turbocharger



Introduction

The Massachusetts Institute of Technology Department of Mechanical Engineering teaches
thermodynamics and fluid mechanics through a pair of classes, Thermal Fluids Engineering
I & II. The courses cover the basic principles of thermodynamics, fluid mechanics, and heat
transfer. This includes the rate processes involved with heat and work transfer, steady flow
components of thermodynami ....etc

[:=Read Full Message Here=:]

An internal combustion engine (ICE) is a heat engine where the combustion of a fuel occurs with an oxidizer (usually air) in a combustion chamber that is an integral part of the working fluid flow circuit. In an internal combustion engine the expansion of the high-temperature and high-pressure gases produced by combustion apply direct force to some component of the engine. The force is applied typically to pistons, turbine blades, rotor or a nozzle. This force moves the component over a distance, transforming chemical energy into useful mechani ....etc

[:=Read Full Message Here=:]

MPFI ( multi point fuel injection system ) Vs CRDI(Common rail direct injection system)

(Actually an open office format. Use open office to open it)
MPFI : mean multi point fuel injection system ie. in petrol engine for gaining more uniform Air Fuel blending fuel is injected at various point in the path of air. this tech is used in light weight car running on petrol. there is also milage improvement due to this.

but in case of DTSI(digital twin spark ignition) : the
engine cylinder consist of two no of spark plu ....etc

[:=Read Full Message Here=:]

By
Amit Kumar Singh


Object
To draw the graph between efficiency and compression ratio and compare with theoretical efficiency.
To draw graph between brake specific fuel consumption and brake power.
To draw graph between power and throttle position.

Conclusion
From the graph it is clear that actual efficiency is increases with the increase in compression ratio but it is quite lower than the theoretical efficiency.
From graph between bsfc and spark timing it is ....etc

[:=Read Full Message Here=:]

Design and analysis of connecting rod 4s S.I engine.

ABSTRACT
Connecting rod is a structural member in the engine, which transfers reciprocating motion into rotary motion of crank shaft
The connecting rod while transferring the power from piston to crank shaft takes load from piston due to combustion process in the combustion chamber
The load acts at a particular crank angle to the max hence the connecting rod is analyzed due to stress developed, due to load conditions and changes mentioned
In this analysis a model of ....etc

[:=Read Full Message Here=:]

to get information about the topic six stroke engine Design full report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-six-stroke-engine-design

http://seminarsprojects.net/Thread-six-stroke-engine

http://seminarsprojects.net/Thread-6-stroke-petrol-engine-ppt

http://seminarsprojects.net/Thread-water-inject-six-stroke-engine

http://seminarsprojects.net/Thread-six-stroke-engine?page=3

http://seminarsprojects.net/Thread-six-stroke-engines

http://seminarsprojects.net/Thread-six-stroke-engine ....etc

[:=Read Full Message Here=:]

design and development of sms based car engine control system to prevent car theft using gsm modem ppt

Abstract

Microprocessors are commonly referred to as general purpose processors as they simply accept the inputs, process it and give the output. In contrast, a microcontroller not only accepts the data as inputs but also manipulates it, interfaces the data with various devices, controls the data and thus finally gives the result. As everyone in this competitive world prefers to make the things easy and simple to handle.In this project we de ....etc

[:=Read Full Message Here=:]

I want a book to design 4 stroke ic engine Just for my project work.. ....etc

[:=Read Full Message Here=:]

Describe the thermal jet engine and the chemical rocket engine stating clearly the difference between them ....etc

[:=Read Full Message Here=:]

Ricardo Powertrain Award


Introduction:
The engine used in the FSAE competition by Oakland University is a Honda 600cc
engine. Knowledge of this engine at Oakland has been growing as it was the chosen
engine for these last few years. The Honda engine used on the 2004 and 2003 car is an
F4i engine, while in the 2002 car and prior to that the F2 was used. The restrictor in the
intake system makes the engine operate very differently to the stock engine. DTA Fast
and Haltech contr ....etc

[:=Read Full Message Here=:]