A switched-mode power supply (switching-mode power supply, switch-mode power supply, switched power supply, SMPS, or switcher) is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently. Like other power supplies, an SMPS transfers power from a DC or AC source (often mains power), to DC loads, such as a personal computer, while converting voltage and current characteristics. Unlike a linear power supply, the pass transistor of a switching-mode supply continually switches between low-dissipation ....etc

[:=Read Full Message Here=:]

full saminar slide ppt on osmotic power generation using salinity gradients

Abstract

Pressure retarded osmosis (PRO) is a potential technology to harvest the renewable osmotic power from the salinity-gradient resources. This study systematically investigated the effects of operating conditions (feed and draw solution concentration, membrane type, membrane orientation, and temperature) and reverse solute diffusion on PRO performance using commercially available osmotic membranes. The PRO performance was improved by decreasing the feed solution ....etc

[:=Read Full Message Here=:]

speed control of dc motor using thyristor dual converter with pid controller

ABSTRACT

The paper describes the design, construction and testing of a closed-loop system for the speed control of a separately excited d.c. motor fed from a dual converter. The dual converter makes possible regenerative braking and reversal of direction of rotation. There is only one firing unit and the firing pulses are diverted to the appropriate converter by a master controller. There are three control loops: one for armature current control, one for adjusting th ....etc

[:=Read Full Message Here=:]

can i get the mat-lab program for speed control of single phase induction motor using vector control method. ....etc

[:=Read Full Message Here=:]

ppt on a combination of shunt hybrid power filter and thyristor controlled reactor for power quality

This paper proposes a combined system of a thyristor-controlled reactor (TCR) and a shunt hybrid power filter (SHPF) for harmonic and reactive power compensation. The SHPF is the combination of a small-rating active power filter (APF) and a fifth-harmonic-tuned LC passive filter. The tuned passive filter and the TCR form a shunt passive filter (SPF) to compensate reactive power. The small-rating APF is used to improve the filtering characterist ....etc

[:=Read Full Message Here=:]

The project is designed to control AC power to a load by using firing angle control of thyristor. Efficiency of such power control is very high compared to any other method.

The project uses zero crossing point of the waveform which is detected by a comparator whose output is then fed to the microcontroller. The microcontroller provides required delayed triggering control to a pair of SCRs through opto isolator interface.

Finally the power is applied to the load through the SCRs in series. This project uses a microcontroller from 8051 family ....etc

[:=Read Full Message Here=:]

Speed Control of Space Vector Modulated Inverter Driven Induction Motor ppt required ....etc

[:=Read Full Message Here=:]

SPEED CONTROL OF AN INDUCTION MOTOR USING INDIRECT VECTOR CONTROL
ABSTRACT
Over the past two decades technological advances in power electronics and an increasing demand for high performance industrial machinery have contributed to rapid developments in digital motor control. This field of study has numerous applications in the areas of manufacturing, mining and transportation but sometime it is difficult to determine which technique is best suited to a particular application.
Induction motor is used as a variable speed drive in many indus ....etc

[:=Read Full Message Here=:]

sir please give me the circuit diagram and schematic diagram of this project (scr power control by ir remote) and related information. ....etc

[:=Read Full Message Here=:]

INTRODUCTION

Boost converter is one of the most popular choices for high-quality rectification. The converter is supplied from a full-wave rectified line voltage and operated so that the input current follows the input voltage. The input current shaping can be achieved using a number of techniques. When the converter is operated at fixed frequency and fixed duty ratio in the discontinuous conduction mode (DCM), the low- frequency component of the input current is approximately proportional to the input ....etc

[:=Read Full Message Here=:]