Please give me complete use of drive in various application of crane in terms of working. ....etc

[:=Read Full Message Here=:]

i need more about zeta converter so my project in M.sc degree is simulation of
zeta ....etc

[:=Read Full Message Here=:]

BASIC HVDC AND CONVERTER OPERATION



Why HVDC rather than HVAC?
Long distances make HVDC cheaper
Improved page link stability
Fault isolation
Asynchronous link

Inverter operation ( = 140 )
Firing is delayed so much that the entire area enclosed between the voltage waveform and the zero line is of opposite polarity.

The equation written in terms of is still correct:

Vd=Vdio -0.766-Id. Xc+Er
2
Vd=-Vdio x 0.8609
However this is usually written in t ....etc

[:=Read Full Message Here=:]

I need a ppt on zeta converter and its application, please show me atleast one. ....etc

[:=Read Full Message Here=:]

I NEED PPT REGARDING DC-DC INTERLEAVED BOOST CONVERTERS APPLIED TO PV PANEL WITH OR WITHOUT MPPT ....etc

[:=Read Full Message Here=:]

non isolated high step up boost converter integrated with sepic converter matlab simulink model ....etc

[:=Read Full Message Here=:]

sir i am doing my project on multiple port dc-dc converter . can u please help me sir. ....etc

[:=Read Full Message Here=:]

pdf files on a novel high step up dc dc converter for a microgrid converter

Abstract

A novel high step-up dc-dc converter for a distributed generation system is proposed in this paper. The concept is composed of two capacitors, two diodes, and one coupled inductor. Two capacitors are charged in parallel, and are discharged in series by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stresses on the main switch and output diode are reduced by a passive clamp circuit. Therefore, ....etc

[:=Read Full Message Here=:]

hello,
I want ppt on Fault detection and mitigation in multilevel statcom ....etc

[:=Read Full Message Here=:]

INTRODUCTION

The fully controlled converter can produce a reversible direct output voltage with output current in one direction, and in terms of a conventional voltage/ current diagram(Fig.1:) is said to be capable of operation in two quadrants, the first and fourth. Such a range of operation is useful for certain purposes, examples being the control of a dc torque motor, i.e. a motor used to provide unidirectional torque with reversible rotation (Fig.2), and a DC transmission page link between two AC systems in which power can be transmitted ....etc

[:=Read Full Message Here=:]