To get full information or details of double buffer frame buffer please have a look on the pages

http://seminarsprojects.net/Thread-rfb-remote-frame-buffer?pid=53226&mode=linear

http://seminarsprojects.net/Thread-rfb-remote-frame-buffer

if you again feel trouble on double buffer frame buffer please reply in that page and ask specific fields in double buffer frame buffer ....etc

[:=Read Full Message Here=:]

Presented By:
Samarth H. Shah, Kai Chen, Klara Nahrstedt Department of Computer Science University of
I. INTRODUCTION
Available bandwidth estimation is a vital component of admis sion control for quality-of-service (QoS) in both wireline as well as wireless networks. In wireless networks, the available bandwidth undergoes fast time-scale variations due to channel fading and error from physical obstacles. These effects are not present in wireline networks, and make estimation of available bandwidth in wireless net ....etc

[:=Read Full Message Here=:]

matlab code particle swarm optimization for optimal sizing and siting of distributed generation

Abstract

Growing concerns over environmental impacts, conditions for improvement of the whole distribution network, and rebate programs offered by
governments have contributed to an increment in the number of DG units in commercial and domestic electrical power output. It is known that the non
optimal size and non optimal placement of DG units may lead to high power losses, bad voltage profiles. Therefore, this paper introduces a sensitivity
analys ....etc

[:=Read Full Message Here=:]

An improvised MOS transistor model suitable for
Geometric Program based analog circuit sizing in
sub-micron technology

A special monomial form of the device model is required by the Geometric program. This article describes the work done in identifying the sources of inaccuracy in this basic model. The strict monomial form has been relaxed. the sizing problem is solved as a series of geometric programs instead of solving it considering as single entity. a folded-cascode op-amp sizing example is used to describe the efficiency of th ....etc

[:=Read Full Message Here=:]

Performance Analysis of CSMA/CA protocol in IEE 802.11 Networks using Backoff mechanism

Abstract: The distributed coordination function (DCF) in the IEE 802.11 standard for wireless LAN is based on the Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) like medium access control protocol. This collision avoidance is implemented by means of backoff procedure which uses a rotating window mechanism. This paper presents a simulation analysis of the slot selection probabilities and the backoff mechanism. The obt ....etc

[:=Read Full Message Here=:]

Buffer Sizing for 802.11 Based Networks

Abstract:-
We consider the sizing of network buffers in 802.11 based networks. Wireless networks face a number of fundamental issues that do not arise in wired networks. We demonstrate that the use of fixed size buffers in 802.11 networks inevitably leads to either undesirable channel under-utilization or unnecessary high delays. We present two novel dynamic buffer sizing algorithms that achieve high throughput while maintaining low delay across a wide range of network con ....etc

[:=Read Full Message Here=:]

Dear sir /Madam ,
u can given the coding for modification in the EDCA TECHNIQUE based on QUALNET simulator. ....etc

[:=Read Full Message Here=:]

AN EFFICIENT APPROACH FOR CAPACITOR SIZING AND LOCATION ON A RADIAL DISTRIBUTION SYSTEM USING ARTIFICIAL INTELLIGENCE TECHNIQUE



INTRODUCTION

The analysis of the customer failure statistics of most
utilities indicates that the distribution system makes the
greatest individual contribution to the unavailability of
supply to a customer. Therefore, the analysis of a
distribution system is an important area of activity. It is
well known that losses in a distribution system are
....etc

[:=Read Full Message Here=:]

My project involves comparing some of the wireless applications in use today by studying how they work. Then focusing on WIMAX (IEE 802.16 standard) which is a part of wireless LAN , the project will deal with the study of the various intrusion attempts and interruptions that it is faced with and their detection. It would also involve a study of the encryption and decryption schemes used. Then finally it would deal with the development of Wireless Intrusion Detection System (IDS) that would attempt to identify computer system and network intrus ....etc

[:=Read Full Message Here=:]

please send me the documentation of buffer overflow attck:a potential problem and its implications ....etc

[:=Read Full Message Here=:]