single phase ac ac matrix converter ppt

Abstract

This paper represents a single phase matrix converter which is designed, simulated and analyzed as a universal converter where different power conversion topologies such as AC-AC, DC- DC & DC- AC with regenerative capability are possible. The desired output for each converter topology was obtained using Matlab-Simulink. Thus SPMC as a single converter capable of all sorts of power conversion is analyzed. ....etc

[:=Read Full Message Here=:]

With these files it is possible to calculate and simulate a dollar, a boost or a buck-boost converter. There is a .m file with the design parameters (Init.m), that the parameters can be changed by the usser, and to simulate the converters this file must be executed previously. On the other hand, there is a matlab function with calculations (this file is called from Init.m).
Finally, there is a model of the three converters. It is possible to add a controller to the model or change the type of load (in the attached file it is considered a resis ....etc

[:=Read Full Message Here=:]

cuk converter ppt..its applications,waveforms,operation and circuit
not now sir.. i wil join in comin days..i urgently need it now so ....etc

[:=Read Full Message Here=:]

sir i need complete operation of bridgeless cuk retifier for pfc applicaton.. and also the details of flow of current direction in it with diagram..

sir i need complete operation of bridgeless cuk retifier for pfc applicaton.. and also the details of flow of current direction in it with diagram..
....etc

[:=Read Full Message Here=:]

Modern Power System Modernised Wave Energy Converter
Vinod Kumar.K , Vinod.A.M.
Department Of
Electrical and Electronics Engineering
Noorul Islam College Of Engineering
Kumaracoil, Thuckalay



Abstract
A variety of technologies have already been proposed to capture energy from ocean waves, but this one requires a minimum of
material, is cheap and robust. Rather than looking at the up and down movements of waves, the proposed method lets the
circular water ....etc

[:=Read Full Message Here=:]

Its a new control algorithm for a matrix converter (MC) induction motor drive system. a new switching strategy, which applies a back-propagation neural network to adjust a pseudo dc bus voltage, to reduce the current harmonics of the induction motor, and a two-degree-of-freedom controller is to improve the system performance. The controller design algorithm can be applied in an adjustable speed control system and a position control system to obtain good transient responses and good load disturbance rejection abilities. The im ....etc

[:=Read Full Message Here=:]

I NEED PPT REGARDING DC-DC INTERLEAVED BOOST CONVERTERS APPLIED TO PV PANEL WITH OR WITHOUT MPPT ....etc

[:=Read Full Message Here=:]

non isolated high step up boost converter integrated with sepic converter matlab simulink model ....etc

[:=Read Full Message Here=:]

pdf files on a novel high step up dc dc converter for a microgrid converter

Abstract

A novel high step-up dc-dc converter for a distributed generation system is proposed in this paper. The concept is composed of two capacitors, two diodes, and one coupled inductor. Two capacitors are charged in parallel, and are discharged in series by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stresses on the main switch and output diode are reduced by a passive clamp circuit. Therefore, ....etc

[:=Read Full Message Here=:]

Hi,
I'm an electrical engineering student and would like to control a Sepic converter using fuzzy logic on MOSFET switch. I use matlab / simulink. I already have almost everything ready, the problem is that I can t find the right inference rule to stabilize the control in 9,6V being that the input source is a solar panel ranging from 5 to 15,5V. Do you have any rule to Sepic logic control using fuzzy logic? Even a surface chart serve. Or a fuzzy simulation file type fis.. Thank you. ....etc

[:=Read Full Message Here=:]