i need a ppt presentation on latest trends in earth moving equipment ....etc

[:=Read Full Message Here=:]

i wnt the ppt at 132/33 kv substation.i am Ashwanee Dubey from lucknow,i have done a vacational training at UPPCL Lucknow.


fh ....etc

[:=Read Full Message Here=:]

SEMINAR ON CONDITION MONITORING OF ELECTRICAL EQUIPMENTS
SUBMITTED BY: -
VINITA AHALAWAT
(EE)
REPORT ON CONDITION MONITORING OF GENRATOR AND TRANSFORMER
Condition Monitoring (CM)
Condition monitoring, also known as predictive maintenance, uses primarily nonintrusive testing techniques, visual inspection, and performance data to assess machinery condition. It replaces arbitrarily timed maintenance tasks with maintenance scheduled only when warranted by equipment condition. Continuing analysis of equipment c ....etc

[:=Read Full Message Here=:]

To get full information or details of condition monitoring on rotating equipments please have a look on the pages

http://seminarsprojects.net/Thread-condition-monitoring-for-generator-and-transformer

if you again feel trouble on condition monitoring on rotating equipments please reply in that page and ask specific fields in condition monitoring on rotating equipments ....etc

[:=Read Full Message Here=:]

equipments required for gsm based digital notice board ? ....etc

[:=Read Full Message Here=:]

High air pollution in terms of particulate matter, SO2, NO2 etc has been observed from the rapidly urbanized cities. This is the most issuing problem for the environmental planners and scientists. The conventional approach of air quality status planning is generally achieved within four phases, namely monitoring, modeling, development and finally execution. Monitoring is achieved by integrative sampling; grab sampling, and passive sampling. But previous studies show that conventional approach to assess the pollution level are not efficient. Sin ....etc

[:=Read Full Message Here=:]

ABSTRACT

Present work is a numerical study of the effect of welding speed on welding induced residual stress in TIG welding. The moving heat source was modelled as a Uniformly Distributed Circular Heat Flow in ANSYS Workbench 15.0 to get the longitudinal and transverse residual stresses which were validated with the experimental data from literature. A study was conducted with the help of the model to assess the influence of change in welding torch speed on residual stresses. The predicted effect of weld speed on residual stress is in good ag ....etc

[:=Read Full Message Here=:]

MOBILE COMPUTING EQUIPMENTS
ABSTRACT
Mobile Computing is a term describes technologies that enable the useis to access the network &om any place at any time Ubiquitous computing and nomadic computing are synonymous with mobile computing. The need to access the network without location constraints Mobile computing is a computing paradigm that allows users to access the netw ork not only from fixed locations, but also while moving or in transit. Mobile computing technology is improving and becoming more feasible Mobile compu ....etc

[:=Read Full Message Here=:]

seminar on earth moving equipment containing
1.introduction
2.need of earthmoving equipment
3.types
4.discription
5.conclusion ....etc

[:=Read Full Message Here=:]

This article is presented by:
YUSUF KIRMANI
STUDY OF QUALITY EQUIPMENTS
BATTERY CHARGER

DEFINITION-A battery charger is a device used to put energy into a secondary cell or (rechargeable) battery by forcing an electric current through it.

BATTERY CHARGER IN DETAIL-A battery charger is a device used to put energy into a cell or (rechargeable) battery by forcing an electric current through it.
The c ....etc

[:=Read Full Message Here=:]