Thanks for the post and would like to get more in the future! ....etc

[:=Read Full Message Here=:]

This article is presented by:
H. Erkan, ASM D.
Hossain, R. Dorsinville,
M.A.Ali A. Hadjiantonis


Abstract
This work proposes a simple and cost effective local access WDM-PON architecture that combines the salient features of both traditional static WDM-PON (i.e., dedicated connectivity to all subscribers with bit rate and protocol transparencies, guaranteed QoS, and increased security) and dynamic WDM-PON (i.e., efficiently utilizing network resources via dynamic wavelength allocation/sharing among end-users) ....etc

[:=Read Full Message Here=:]

Burst Rescheduling with Wavelength and Last-hopFDLReassignment in WDM Optical Burst Switching Networks



I. INTRODUCTION
Wavelength division multiplexed (WDM) optical networks
are a promising candidate for the next generation backbone
transport networks. Optical burst switching (OBS), as described
in , , , is able to strike a balance between
optical circuit and packet switching , , , .
A burst is formed at the ingress node by assembling a
number of I ....etc

[:=Read Full Message Here=:]

To get full information or details of optical communication please have a look on the pages

http://seminarsprojects.net/Thread-optical-fiber-communication-full-report?pid=11812&mode=threaded

http://seminarsprojects.net/Thread-optical-fiber-communication-full-report?pid=55503&mode=threaded

http://seminarsprojects.net/Thread-optical-fiber-communication-full-report?pid=13756&mode=threaded

http://seminarsprojects.net/Thread-m-tech-thesis-on-optical-fiber-communication-pdf

if you again feel trouble on optical communication please reply in that ....etc

[:=Read Full Message Here=:]

Abstract
Most device drivers have one ulterior motive and one target to achieve - deliver the maximum using the minimum. No matter how stable or feature rich a device driver might be, if it cannot perform in terms of high throughput and low CPU utilization, it is as good as any other run of the mill driver.The objective of this topic is to use the thinking out of the box concept and expose techniques, which go beyond just good programming principles to get that extra edge which can put your next driver into the elite group of high perform ....etc

[:=Read Full Message Here=:]

In optical WDM networks, since each lightpath can carry a huge mount of traffic, failures may seriously damage the end-user applications.As a result, fault-tolerance is an important issue in these networks. The primary path is the light path which carries traffic during normal operation. in case of a failure, the traffic is rerouted on a backup path. a reliable and fault-tolerant routing algorithm is discussed in this paper for establishing primary and backup path. load balancing is used to establish the primary path. In this method, the pag ....etc

[:=Read Full Message Here=:]

To get full information or details of optsim software please have a look on the pages

http://seminarsprojects.net/Thread-opto-electronics-in-large-array-gas-detector-systems

http://seminarsprojects.net/Thread-opto%E2%80%93electronics-sensor-system

if you again feel trouble on optsim software please reply in that page and ask specific fields in optsim software ....etc

[:=Read Full Message Here=:]

Abstract
Dense Wavelength-division multiplexing (DWDM) technology offers tremendous transmission capacity
in optical fiber communications. However, switching and routing capacity lags behind the transmission
capacity, since most of today s packet switches and routers are implemented using slower
electronic components. Optical packet switches are one of the potential candidates to improve switching
capacity to be comparable with optical transmission capacity. In this paper, we present an optically
transparent ATM (OPATM) switch tha ....etc

[:=Read Full Message Here=:]

Design of p-Cycles for full node protection in WDM Mesh Networks


INTRODUCTION

WDM techniques enable a single fiber to carry multiple
non-overlapping channels, and a single channel can operate
at the speed of up to 100 Gbps. WDM networks carry huge
amounts of traffic. As optical WDM networks are occasionally
prone to a single failure of network infrastructure (e.g., a fiber
cut or a node failure), survivability is an essential requirement
in the design of WDM networks.

NODE AND LINK PROTE ....etc

[:=Read Full Message Here=:]

to get information about the topic optsim projects full report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-opto%E2%80%93electronics-sensor-system

http://seminarsprojects.net/Thread-opto-electronics-in-large-array-gas-detector-systems ....etc

[:=Read Full Message Here=:]