I want to know in which method the switches & DC sources are reduced & what are absolute firing angle for each switches . i have attached my base paper pls suggest any idea reg tis ....etc

[:=Read Full Message Here=:]

Abstract
It is often argued that time-triggered (TT) architectures are the most suitable basis for safety-related applications as their use tends to result in highly-predictable system behaviour. This predictability is increased when TT architectures are coupled with the use of co-operative (or non pre-emptive) task sets.
Despite many attractive properties, such time-triggered co-operative (TTC) and related time-triggered hybrid (TTH) architectures rarely receive much attention in the research literature. One ....etc

[:=Read Full Message Here=:]

RATE & DELAY GUARANTEES PROVIDED BY CLOSE PACKET SWITCHES WITH LOAD BALANCING

Abstract: In this paper, we consider an overarching problem that encompasses both performance metrics. In particular, we study the network capacity problem under a given network lifetime requirement. Specifically, for a wireless sensor network where each node is provisioned with an initial energy, if all nodes are required to live up to a certain lifetime criterion, Since the objective of maximizing the sum of rates of all the nodes in the network can lead to a sev ....etc

[:=Read Full Message Here=:]

DM74LS373/DM74LS374 3-STATE Octal D-Type Transparent Latches and
Edge-Triggered Flip-Flops

General Description

These 8-bit registers feature totem-pole 3-STATE outputs designed specifically for driving highly-capacitive or relatively low-impedance loads. The high-impedance state and increased high-logic level drive provide these registers with the capability of being connected directly to and driving the bus lines in a bus-organized system without need for interface or pull-up components. They are part ....etc

[:=Read Full Message Here=:]

RATE & DELAY GUARANTEES PROVIDED BY CLOSE PACKET SWITCHES WITH LOAD BALANCING-NETWORKING

Abstract: In this paper, we consider an overarching problem that encompasses both performance metrics. In particular, we study the network capacity problem under a given network lifetime requirement. Specifically, for a wireless sensor network where each node is provisioned with an initial energy, if all nodes are required to live up to a certain lifetime criterion, Since the objective of maximizing the sum of rates of all the nodes in the network can l ....etc

[:=Read Full Message Here=:]

How would you like to be able to energize any electrical device in your home., from any where in the world. and do it without paying for a telephone call? You can do it and it's perfectly legal. With the Telephone Triggered Switches you can do just that. The device described here is a circuit, which responds to the sound of the telephone Deli There is no need to make any hard wire connections to the telephone line, and it is this feature which permits you to build and use this device without any permission from the Department of Telecommunicati ....etc

[:=Read Full Message Here=:]

Seminar on
TTCAN
Time Triggered Controller Area Network

Abstract
As early as the 1950s electronic elements started to appear in

passenger vehicles. Over the years the electronic content and

complexity continued to grow in vehicles. In 1983, it was formally

stated at Robert Bosch AG that a real-time communication page link was

required between three electronic control units: engine control,

automatic transmission control and the anti-skid braking system.
Despite the existence of a number of ....etc

[:=Read Full Message Here=:]

SHASHIDHAR KOPPARAD
SACHIN K GOWDA
PRAVEEN S K
MOHAMMED SUHEL

PROJECT GUIDE:
M.J.SAMPATH KUMAR
Lecturer
E&C Dept
SJCE Mysore




Brief description about project:

The aim of the project is to control home appliances like Television, air conditioner etc., using voice command given by the user who wishes to access it remotely. The overall module should be miniature to enable portability. Frequency modulation has advantages over other kinds as it has greater freedom from interference. Hence we use fr ....etc

[:=Read Full Message Here=:]

i hav seminar on 20th so pls fwd the materials related to the topic mems rf switches.pls
to the mail id- [email protected] ....etc

[:=Read Full Message Here=:]

MEMS SWITCHES

INTRODUCTION

Compound solid state switches such as GaAs MESFETs and PIN diodes are widely used in microwave and millimeter wave integrated circuits (MMICs) for telecommunications applications including signal routing, impedance matching networks, and adjustable gain amplifiers. However, these solid-state switches have a large insertion loss (typically 1 dB) in the on state and poor electrical isolation in the off state. The recent developments of micro-electro-mechanical systems (MEMS ....etc

[:=Read Full Message Here=:]