IMPLEMENTATION OF DSP BASED SENSORLESS CONTROL WITH
DIRECT BACK-EMF DETECTION METHOD FOR BLDC MOTOR

ABSTRACT
This thesis presents a back EMF sensing scheme, direct back EMF detection, for
sensorless Brushless DC (BLDC) motor drives with a DSP based controller. Using this
scheme, the motor neutral voltage is not needed to measure the back EMF. Instead the
method utilizes the high-speed A/D converter channels, which are available on a DSP
controller. The true back EMF of the floating motor winding is detecte ....etc

[:=Read Full Message Here=:]

difference between chopper fed drives and converter fed drives pdf

If the source of supply is d.c. (for example in a battery vehicle or a rapid transit system) a chopper-type converter is usually employed. The basic operation of a single-switch chopper was discussed in topic 2, where it was shown that the average output voltage could be varied by periodically switching the battery voltage on and of for varying intervals. The principal difference between the thyristor-controlled rectifier and the chopper is that in the former the motor current ....etc

[:=Read Full Message Here=:]

A Robust Sensorless Direct Torque Control of Induction Motor Based on MRAS and Extended Kalman Filter
Presented By:
Mustapha MESSAOUDI, Habib KRAIEM, Mouna BEN HAMED, Lassaad SBITA and Mohamed Naceur ABDELKRIM

Abstract
In this paper, the classical Direct Torque Control (DTC) of Induction Motor (IM) using an open loop pure integration suffers from the well-known problems of integration especially in the low speed operation range is detailed. To tackle this problem, the IM variables and parameters estimation is per ....etc

[:=Read Full Message Here=:]

please sir send me the sensorless induction motor ppt ....etc

[:=Read Full Message Here=:]

Direct torque control (DTC) is one method used in variable frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors. This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor. ....etc

[:=Read Full Message Here=:]

CHAIN DRIVES IN LOW TORQUE DRIVES AND REDUCING PULSATIONS
INTRODUCTION TO DRIVES

Mechanical components used for power transmission. It may be belt, chain or gear depending on engine design parameters like - Distance between crankshaft and camshaft, engine maximum speed, engine-torque and engine construction cost. - Power transmission is done from one shaft to another shaft which may or may not rotate at same speed.

CHAIN DRIVES ....etc

[:=Read Full Message Here=:]

SPEED CONTROL OF SYNCHRONOUS MOTOR BY USING VARIABLE FREQUENCY DRIVES

ABSTRACT :

A novel open-loop speed control method for induction motors that provides high output torque and nearly zero steady-state speed error at any frequency is presented. The control scheme is based on the popular constant volts per hertz (V/f) method using low-cost open-loop current sensors. Only stator current measurements are needed to compensate for both stator resistance drop and slip frequency. The scheme proposed fully compensates for ....etc

[:=Read Full Message Here=:]

This article is presented by:
O. Barambones , A.J. Garrido , F.J. Maseda and P. Alkorta Speed Sensorless Vector Control of Induction Motors Based on
Robust Adaptive Variable Structure Control Law

ABSTRACT
A novel sensorless adaptive robust control law is proposed to improve the trajectory tracking performance of induction motors. The proposed design employs the so called vector (or field oriented) control theory for the induction motor drives and the designed contro ....etc

[:=Read Full Message Here=:]

FLUX ESTIMATORS FOR SPEED-SENSORLESS
INDUCTION MOTOR DRIVES



Abstract

This thesis deals with flux estimators for speed-sensorless induction motor drives. To enhance
the stability and the performance of state-of-the-art sensorless drives, new flux estimator
designs based on the standard motor model are proposed. Theoretical and experimental
research methods are both used. The dynamics and stability of flux estimators
are analyzed using linearized models, and the effects of parameter errors are investig ....etc

[:=Read Full Message Here=:]

SPEED SENSORLESS SEPARATELY EXCITED DC MOTOR DRIVE WITH AN ADAPTIVE OBSERVER


ABSTRACT
This project deals with a speed sensorless separately excited dc motor drive which uses the adaptive observer to estimate the rotor speed. The stability analysis of speed estimation is carried out. The modified feed forward control is integrated with the adaptive observer to simplify the implementation. The design guideline for feedback gain and the speed controller are also given to assure system stability for the entire operat ....etc

[:=Read Full Message Here=:]