Abstract:
This project focuses on developing an embedded system to control the operation of the stepper motor using micro controller. It consists of two parts; one is transmitter which consists of pc, level converter, microcontroller, RF transmitter. Another one is receiver which consists of RF receiver, microcontroller, stepper motor and stepper motor driver.
If we want to control the motor the information is given to the microcontroller using pc. Microcontroller recognizes the data and provides the appropriate information to the RF t ....etc

[:=Read Full Message Here=:]

to get information about the topic stepper motor control using 8051 microcontroller related topic refer the page link bellow

http://seminarsprojects.net/Thread-speed-control-of-stepper-motor-using-microcontroller-8051 ....etc

[:=Read Full Message Here=:]

To get full information or details of solar tracking system using atmega16 and stepper motor please have a look on the pages

http://seminarsprojects.net/Thread-microcontroller-based-solar-tracking-system?pid=52938&mode=threaded

http://seminarsprojects.net/Thread-microcontroller-based-solar-tracking-system

http://seminarsprojects.net/Thread-microcontroller-based-solar-tracking-system?pid=97767&mode=linear

if you again feel trouble on solar tracking system using atmega16 and stepper motor please reply in that page and ask specific fields ....etc

[:=Read Full Message Here=:]

This AVR tutorial will discuss interfacing Light Emitting Diodes with Atmel's AVR series of Microcontrollers. A LED is an acronym for Light Emitting Diode and is basically a electronic device which emits light when an electric current flows through it. The electronic symbol for a LED is : LED Symbol

General purpose LEDs used in digital circuits require around 75mA or less and so we usually use resistors to limit the current flowing through the LED when it is connected within a circuit as shown below. The resistance of the resistor is calcula ....etc

[:=Read Full Message Here=:]

i need to do this project so please send me all ta available details. ....etc

[:=Read Full Message Here=:]

i need info about stepper motor about stepper motor interface using 8251 ppt ....etc

[:=Read Full Message Here=:]

A solar tracker is a device that orients a payload toward the Sun. Payloads are usually solar panels, parabolic troughs, fresnel reflectors, mirrors or lenses.

For flat-panel photovoltaic systems, trackers are used to minimize the angle of incidence between the incoming sunlight and a photovoltaic panel. This increases the amount of energy produced from a fixed amount of installed power generating capacity. In standard photovoltaic applications, it was predicted in 2008-2009 that trackers could be used in at least 85% of commercial installat ....etc

[:=Read Full Message Here=:]

i want ppts or any document on stepper motor interfacing with 8051 ....etc

[:=Read Full Message Here=:]

Guided by:
Ms. Monika Sharma

Prepared by:
Akshay Patel
Rohan Shah


Introduction:

A stepper motor (or step motor) is a brushless, synchronous electric motor that can divide a full rotation into a large number of steps.
Stepper motors are similar to switched reluctance motors (which are very large stepping motors with a reduced pole count, and generally are closed-loop commutated.)

Fundamentals of operation

Stepper motors operate differently from DC brush motors, which rotate when voltage ....etc

[:=Read Full Message Here=:]

automatic railway gate controller using stepper motor ppt

ABSTRACT

This project work aims at the design, development, fabrication and testing of working model entitled Automatic Railway Gate Controller. It is basically related to Radio communication and signalling system. An Automatic Railway gate controller is unique in which the railway gate is closed and opened or operated by the Train itself by eliminating the chances of human errors.The largest public sector in India is the Railways. The network of Indian Railways covering the length and ....etc

[:=Read Full Message Here=:]