P V Ramaiah J. and G Krishnaiah2
I Department of Mechanical Engineering, Srikalahasteeswara Institute of Technology, Andhra Pradesh, India 2Department of Mechanical Engineering, SV University College of Engineering, Andhra Pradesh, India
The manuscript was received on 15 June 2006 and was accepted after revision for publication on 30 May 2007. DOl: 1O.1243/09544062JMES411


abstract

The paper deals with modelling and design of a friction damper. This has been done in four phases. In the first pha ....etc

[:=Read Full Message Here=:]

How to Use IIC Module on M68HC08, HCS08, and HCS12 MCUs


Introduction
This application note is an example of how to use the IIC
module on Freescale s MCUs. The IIC module can be
used in the master or slave mode, respectively. In this
case, the master mode communicates with the serial
EEPROM because the IIC bus is used mainly for
communication between an MCU and a IIC peripheral
device. The IIC bus can communicate directly between
two MCUs, but the SPI bus is better for this ....etc

[:=Read Full Message Here=:]

To get full information or details of accident identification with vibration sensor and using rf technology please have a look on the pages

http://seminarsprojects.net/Thread-accident-identification-using-rf

if you again feel trouble on accident identification with vibration sensor and using rf technology please reply in that page and ask specific fields ....etc

[:=Read Full Message Here=:]

To get full information or details of train collision avoidance using vibration sensor please have a look on the pages

http://seminarsprojects.net/Thread-train-collision-avoidance-using-vibration-sensor-micro-controller

if you again feel trouble on train collision avoidance using vibration sensor please reply in that page and ask specific fields in train collision avoidance using vibration sensor ....etc

[:=Read Full Message Here=:]

i need to know the full informaton about the automatic accident identification and alert system using vibration sensor and rf technology?
please any body give the information how it works ....etc

[:=Read Full Message Here=:]

I want to know project report on this topic. mainly it includes abstract and equipment and also block diagram. ....etc

[:=Read Full Message Here=:]

Smart Vibration Sensor


In this vibration sensor alarm circuit,
initially, when power switch
S1 is flipped to on position, power
indicator LED1 lights up immediately.
IC LM555 (IC1), wired as a simple latch
circuit with control input, is powered
and R-C components R4 and C5 connected
at its reset pin 4 force the latch
to standby mode (with inactive low
output). The circuit is driven into sleep
mode.

As a result, control input
pins 2 and 6 of IC1 latch are grounded.
Output ....etc

[:=Read Full Message Here=:]

i need full project on seminar on earthquake vibration control using modified frame shear wall ....etc

[:=Read Full Message Here=:]

This article is presented by:
Br el & Kj r
2850 N rum
Denmark

ABSTRACT
Since man began to build machines for industrial use, and especially since motors have been used to power them, problems of vibration reduction and isolation have engaged engineers. Gradually, as vibration isolation and reduction techniques have become an integral part of machine design, the need for accurate measurement and analysis of mechanical vibration has grown. This need was largely satisfi ....etc

[:=Read Full Message Here=:]

To get full information or details of abstract of wireless accident identification using vibration sensor please have a look on the pages

http://seminarsprojects.net/Thread-automatic-accident-identification-system-using-wireless-technology

if you again feel trouble on abstract of wireless accident identification using vibration sensor please reply in that page and ask specific fields in abstract of wireless accident identification using vibration sensor ....etc

[:=Read Full Message Here=:]