I would like to get the model, circuit diagram and synopsis about POWE HOUSE MONITORING THROUGH RADIO FREQUENCY ....etc

[:=Read Full Message Here=:]

INTRODUCTION

Miniaturization has been a key contributor to advances in electronic technology. Certainly, miniaturization has been made possible mostly through remarkable breakthroughs in reducing the size of active components. But as integrated circuits get smaller and more complex, there is an increasing need to also reduce the space required for the supporting passive components. If any of the electronic devices such as cellphone, camcorder, computer, or other consumer electronics system is opened, one or two circuit boards on which are mo ....etc

[:=Read Full Message Here=:]

Comfortableness and quality is most important thing in shoes for walking on concrete floors.For this,now lot of brand in shoes available in the markets. ....etc

[:=Read Full Message Here=:]

Stereoscopic Passive Millimeter-Wave Imaging and Ranging

Thomas L thi and Christian M tzler, Senior Member, IEE


Abstract

This paper presents the first stereoscopic range measurements
at a wavelength of 3.3 mmand discusses the accuracy of
this new method. The synthesis of passive millimeter-wave imaging
and stereoscopy combines the advantages of both principles, naturally
looking high-contrast images and superior poor-weather performance
(compared to visible and infrared wavelengths), as well
as the pas ....etc

[:=Read Full Message Here=:]

The solar house: passive heating and cooling

ABSTRACT:

Passive solar heating and passive cooling approaches known as natural conditioning provide comfort throughout the year by reducing, or eliminating, the need for fossil fuel. Yet while heat from sunlight and ventilation from breezes is free for the taking, few modern architects or builders really understand the principles involved.
ISBN: 1931498121 ....etc

[:=Read Full Message Here=:]

Six-Stroke, High-Efficiency Quasiturbine Concept Engine
With Distinct, Thermally-Insulated
Compression and Expansion Components

George Marchetti and Gilles Saint-Hilaire


Need to increase engine thermal efficiency. This paper presents a Quasiturbine thermal management strategy in the development of high-efficiency engines for the 21st century. In the concept engine, high-octane fuels are preferred because higher engine efficiencies can be attained with these fuels. Higher efficiencies mean less fuel consumption and lower at ....etc

[:=Read Full Message Here=:]

Abstract

The fiber/matrix adhesion is most likely to control the overall mechanical behavior of fiber-reinforced composites. An interfacial reaction may result in various morphological modifications to polymer matrix microstructure in proximity to the fiber surface. The interactions between fiber and polymer matrix during thermal conditioning and thermal shock are important phenomena. Thermal stresses were built-up in glass fiber-reinforced epoxy composites by upthermal shock cycles (negative to positive temperature exposure) for different dur ....etc

[:=Read Full Message Here=:]

thermally comfortable passive house for tropical uplands good ....etc

[:=Read Full Message Here=:]

Abstract

In many countries located close to the equator, such as India, Sri Lanka, Myanmar, Thailand, Malaysia, Indonesia, and countries in parts of Africa and South America, certain regions can be considered tropical uplands. In such regions, the cold discomfort that occurs during the night and warm discomfort that occurs during the daytime could become a problem unless houses are planned with careful consideration. It is shown using computer simulation with case-studies carried out for the climatic data pertaining to tropical uplands of Sr ....etc

[:=Read Full Message Here=:]

Thermal shock on interfacial adhesion of thermally conditioned Glass fiber/epoxy

The fiber/matrix adhesion is most likely to control the overall mechanical behavior of fiber-reinforced composites. An interfacial reaction may result in various morphological modifications to polymer matrix microstructure in proximity to the fiber surface. The interactions between fiber and polymer matrix during thermal conditioning and thermal shock are important phenomena.

Thermal stresses were built-up in glass fiber reinforced epoxy c ....etc

[:=Read Full Message Here=:]