hello
yes pls send this free model so i will be able to use it to exercise the ansys with it. if any problem i still can have an easier model from you like '3dbracket' or even a simple 'bolt'.
thank you
Azimi ....etc

[:=Read Full Message Here=:]

Internal winding faults resulting from the degradation of transformer winding insulation can be catastrophic and hence expensive. In the new environment of deregulation, utilities therefore are needing inexpensive methods employed to detect such faults in the incipient stage.

The development of an accurate internal fault diagnostic technique for transformers must be based on analysis of quantities from faults scenarios.

Considering the safety of personal, the damage that will occur in the transformer, the consumed time, and related c ....etc

[:=Read Full Message Here=:]

Increases in the installed capacity and the interconnection of the transmission networks lead to possibility of
fault currents. Fault currents results from various kinds of high voltage stresses caused by lighting and short circuits
or other system disturbances, which send a surge power through the grid.
One of the usages of superconductors is protecting electronic devices and systems from short circuit .
There are three types of superconductors fault current limiters (SFCL): resistive, inductive and hybrid. Protection of
scheme from cu ....etc

[:=Read Full Message Here=:]

The modeling and simulation of a grid-connected wind power system or WECS (acronym for Wind Energy Conversion System) has been carried out. Our goal is to design and test a power system of 14.9 KVA capacity, operating at 440V, 20m / s wind speed base, induction generator based on wind power system through. MATLAB simulation. The various components of a wind power system, namely wind turbine, generator, control system, rectifier-inverter, battery, load and other equipment, including transformers, network, etc., were Decided according to the scop ....etc

[:=Read Full Message Here=:]

Presented By:
Marcin Janicki*, Marcin Daniel, Michal Szermer, Andrzej Napieralski

Abstract
The proper design and simulation of modern electronic microsystems oriented towards environment monitoring requires accurate models of various ambient sensors. In particular, this paper presents a comprehensive model of an ion sensitive eld effect transistor (ISFET). The model can be employed straightforwardly for simulations at device, circuit or system level. First, the model was validated with electrical measurements and simulatio ....etc

[:=Read Full Message Here=:]

Introduction

In the satellite launch vehicle, the Avionics system is proposed to be based on MIL-STD 1553B BUS. A number of interface modules for application such as sensor data acquisition, vehicle sequencing, control generation, command posting etc. are being designed with this interface. These interface modules are then connected to the onboard computers via the 1553B BUS. These modules have to be tested separately and evaluated and also confirm their compliance with the 1553B BUS standard before being integrated as the Avionics System. T ....etc

[:=Read Full Message Here=:]

Abstract

In paper the fundamental question about optimal interaction between the controlling stimuli generated by the active (powered) and the passive (unpowered) drives of the robotic systems have been studied. A mathematical statement of the problem has been proposed that is suitable to study this question for the semi-passively actuated n-degree-of-freedom robotic systems. The problem is formulated as an optimal control problem for n-degree-of-freedom mechanical system models a semi-passively actuated robot. We take into account the inter ....etc

[:=Read Full Message Here=:]

i want modelling and thermal analysis of diesel engine piston with catia and ansys pdf material ....etc

[:=Read Full Message Here=:]

STRUCTURAL ANALYSIS OF A 4.5 TON TRUCK CHASSIS
Truck chassis forms the structural backbone of a commercial vehicle. the components and payload placed are supported by the chassis. road roughness and excitation by vibrating components are the major sources of vibration of the truck. The vibration characteristics of the truck chassis are detailed in this article. natural frequencies and mode shapes study are also included in this study. Observations are made about the stress distribution and displacement on the truck. Here, finite e ....etc

[:=Read Full Message Here=:]

gjygkk hegsfkrhg euf7oieu foieufeuf efyrg rrogiroigpr grug rgurpgr igruir gorsgurg yrg rgur gourg ru9goiuroigu rgr gorug srugpoiru gruo ....etc

[:=Read Full Message Here=:]