IPPAM within the framework of the project is underway to build a mechatronic prosthesis under equipped with pneumatic artificial muscles. The aim of this PhD project is study of the influence of an actuated prosthesis to a step pattern of leg amputees. The rigidity of the prosthesis only adaptable, and there must be a certain torque can be delivered. Students are first asked to operate with a control panel (displays, knobs, ..) for the prosthesis design. The prosthesis must possess a number of operating modes. It must be possible for the pressu ....etc

[:=Read Full Message Here=:]

Abstract:
A modified friction damper is presented to enhance the performance of conventional friction damper and semi-active variable friction damper. An additional plate is provided between the two sliding plates of a conventional friction damper which results in an additional sliding interface with the same normal (clamping) force. Similar modification is also made to semi-active variable friction damper (SAVFD) to enhance its performance. The enhancement in the performance of the benchmark building is studied under across wind loads ....etc

[:=Read Full Message Here=:]

Hi Im Jason here.Does anyone done or did the project about this title before?Quite headache with this topic as my lecturer can't guide me in the right way of doing it @@.. ....etc

[:=Read Full Message Here=:]

pls give the details of this project Wind-Driven Self-Excited Induction Generator With Voltage and Frequency Regulated by a Reduced-Rating Voltage Source inverter ....etc

[:=Read Full Message Here=:]

microcontroller based speed control of separately excited dc motor

Abstract

A PIC microcontroller based closed loop speed control scheme has been developed for the speed control of a separately excited DC motor fed from PV array. An IGBT based boost converter is used as an interface between PV array and the DC motor. The microcontroller has been programmed to automatically vary the duty cycle of the boost converter depending upon the set/required speed of the motor. The DC motor model has been developed and the complete simulink model of the ....etc

[:=Read Full Message Here=:]

Abstract
Due to increasing demand for speech communications, efficient techniques in low-rate speech coding are of interest.Here a new compression technique using root cepstral analysis has been proposed. Implementing the proposed method causes the coder to deal with root cepstrum coefficients instead of speech samples. The main idea in using root cepstrum analysis is that some of the trivial coefficients can be ignored to send toward the decoder. Thus considerable reduction in the total bit-rate is achieved. Moreover it has the advanta ....etc

[:=Read Full Message Here=:]

To get full information or details of transfer function of a separately excited dc generator please have a look on the pages

http://seminarsprojects.net/Thread-speed-sensorless-separately-excited-dc-motor-drive-with-an-adaptive-observer-report

if you again feel trouble on transfer function of a separately excited dc generator please reply in that page and ask specific fields ....etc

[:=Read Full Message Here=:]

I think it is very useful to my project. i am doing the project on self exited induction generator control by voltage and frequency control ....etc

[:=Read Full Message Here=:]

SPEED SENSORLESS SEPARATELY EXCITED DC MOTOR DRIVE WITH AN ADAPTIVE OBSERVER


ABSTRACT
This project deals with a speed sensorless separately excited dc motor drive which uses the adaptive observer to estimate the rotor speed. The stability analysis of speed estimation is carried out. The modified feed forward control is integrated with the adaptive observer to simplify the implementation. The design guideline for feedback gain and the speed controller are also given to assure system stability for the entire operat ....etc

[:=Read Full Message Here=:]

Abstract
Drilling assisted by axial vibration at low frequency is a promising machining process because, by naturally fragmenting chips, it can improve both productivity by canceling stripping operations and work piece quality by decreasing negative effects due to chip friction. Based on a theory of self-excited vibrations, a drilling device has been developed which is described in this paper. This technology is very compact and can used on any conventional machine tool. However the experiments on these machine tools are quite difficul ....etc

[:=Read Full Message Here=:]