Improvement In The Operating Characteristics Of
Internal Combustion Engine Using Variation In
Compression Ratio

Yadav Milind S.1, Wankhade P.A.2
1Finolex Academy of Management & Technology, Ratnagiri - 415639, Maharashtra, India
Email: [email protected]
2Veermata Jijabai Technological Institute, Mumbai - 400019, Maharashtra, India


Abstract - Vast developments are taking place in the field of
internal combustion engine especially to improve the fuel
economy and to reduce the emission percentage in the
exhaust gase ....etc

[:=Read Full Message Here=:]

Transonic Combustion Inc. is a Los Angeles-based cleantech company that is developing supercritical fuel injection systems that enable injection ignition in internal combustion engines.

On October 25, 2010, Transonic presented a technical paper detailing its novel new injection ignition combustion process at the SAE 2010 Powertrain Fuels and Lubricants Meeting in San Diego CA.

On September 1, 2010, the World Economic Forum announced the company as a Technology Pioneer for 2011. ....etc

[:=Read Full Message Here=:]

1) Combustion control using optical fiber.
can you pleases send report, material & presentation on the above topic as that one is from this following references
SAE 881638
SAE 902138
SAE 902126

1. Witze, P.O., Hall, M.J., Wallace, J.S..: Fiber-Optic Instrumented Spark Plug for Measuring Early Flame Development in Spark Ignition Engines, SAE 881638
2. Spicher, U., B cker, H.: Optical Fiber Technique as a Tool to Improve Combustion EfficiencySAE 902138
3. Spicher, U., B cker, H.: Correlation of Flame Propagation and In-Cylinder Pressur ....etc

[:=Read Full Message Here=:]

SEMINAR ON OPTICAL FIBRE MEASUREMENTS



INTRODUCTION

Measurement on optical fibers which characterize the fiber.
Transmission characteristics
Geometrical and optical characteristics
Mechanical characteristics

Fiber Dispersion Measurements

Indication of distortion to optical signals.
Determination of bandwidth of the fiber.
Transmission characteristic of an optical fiber.
In multimode fibers, inter modal dispersion and in single mode, intra modal dispersion takes place .
Characterized by ....etc

[:=Read Full Message Here=:]

optical measurement technique has become increasingly common for the past few years. In particular, the technique of optical fibre is often used to detect the spread of the flames. With optical sensors ignition process can be studied with a temporal and spatial resolution. An optical sensor in the cylinder was developed and tested to analyze ignition of the mixture and the light emission of combustion gases. The sensor consists of eight optical sensors mounted in a conventional spark plug.

The results show a good correlation between the meas ....etc

[:=Read Full Message Here=:]

In-cylinder pressure measurements are the common tool
to analyze and to improve the combustion process of SI
engines. New engine concepts like direct injection SI
engine, dual-plug ignition system and four or five valve
engines require modern measurement techniques which
provide further information about the combustion process.
Optical fibre technique is more suitable to gain
more versatile data than conventional pressure transducers.
Many optical in-cylinder sensor techniques have been
already presented either to monitor flame propaga ....etc

[:=Read Full Message Here=:]

For more information about combustion control using optical fibre

http://seminarsprojects.net/Thread-combustion-control-using-optical-fiber

http://seminarsprojects.net/Thread-speed-control-of-stepper-motor-using-at89c51 ....etc

[:=Read Full Message Here=:]

Kindly sent me(chirag gupta) ppt on combustion stability in i.c engine ....etc

[:=Read Full Message Here=:]

Abstract:

In this project we show how we control multiple systems using one wire system. To control with one wire system is a smart control system. There is only one wire between transmitter and receiver circuit. It is possible to control the electrical appliances with the help of mobile control also. In this we use one DTMF generator circuit and one receiver circuit. DTMF generator circuit transmits the signal to the receiver circuit. Receiver circuit receives this signal and then controls the electrical appliances circuit with th ....etc

[:=Read Full Message Here=:]

Hi Team,
I need a detailed project regarding fault detection of optical fibre using 8051

Thank you ....etc

[:=Read Full Message Here=:]