optimising free space optics for wireless networks seminar report and slide needed some one please help
some good electrical project reports are also welcomed ....etc

[:=Read Full Message Here=:]

details of synopsis on machine parameters for alloy steel. ....etc

[:=Read Full Message Here=:]

K.J.V. ALLOY CONDUCTORS PVT. LTD.



COMPANY PROFILE :
We started our operations with manufacturing AAC (All Aluminium Conductor), ACSR (Aluminium Conductor Steel Reinforced), Bare Aluminum Wire & Strips, Bare Aluminum Alloy Wire, in theyear 1989. Subsequently we included AAC (All Aluminium Alloy Conductor) & Paper Covered (Insulated) Wire & Strips to our product mix for distribution & transmission power lines .

SUPPLIES TO :
We have supplied our products to maj ....etc

[:=Read Full Message Here=:]

synopsis for optimising the machining parameters of alloy steel
synopsis for optimising the machining parameters of alloy steel ....etc

[:=Read Full Message Here=:]

Aluminium conductor steel-reinforced cable (ACSR) is a type of high-capacity, high-strength stranded conductor typically used in overhead power lines. The outer strands are high-purity aluminium, chosen for its excellent conductivity, low weight and low cost. The center strand, or strands is/are of steel for additional strength to help support the weight of the conductor. Steel is higher strength than aluminium which allows for increased mechanical tension to be applied on the conductor. Steel also has lower elastic and inelastic deformation (p ....etc

[:=Read Full Message Here=:]

They re practically twins. Some might say this about superalloys and titanium, but as with most twins, there are a few subtle differences.

Materials like nickel-base, chrome-base, and iron-base superalloys are extremely heat resistant, even more than titanium, so most of the heat produced during machining is absorbed by the cutting edge.

This can wreak havoc on the cutting tool and cause damage ranging from crater wear, to plastic deformation, to complete tool failure.

Most superalloys are not flammable, so they can be machined with ceramic ....etc

[:=Read Full Message Here=:]

ABSTRACT:
Conventional closed die forging, is widely used for manufacture of superalloy parts. Despite recent technological advancements in the area of forging design, empirical and trial-and-error methods are still widely used in forging super alloy materials. This paper investigates the effect of flash thickness and various geometrical forging design parameters including internal and external drafts and internal and external corner radii, on the die cavity filling, forging load and raw material cost when forging Nimonic80-A a superal ....etc

[:=Read Full Message Here=:]

Abrasive Jet Machine

Introduction
Abrasive jet machining (AJM) is a non-traditional machining
process that can machine material without generating heat and
shock.
Abrasive jet machining (AJM) is commonly used for Cutting,
Cleaning, Drilling and Etching operation

Mechanism of AJM

Fine particles are accelerated in
gas stream .

The particles are directed towards
the focus of machining.

As the particle impacts the surface,
it causes a small fractu ....etc

[:=Read Full Message Here=:]

Abstract:
All aluminum alloy conductors (AAC) are made of high-strength aluminum-magnesium-alloy silicon. These conductors are designed to provide a better resistance to weight ratio and offer improved electrical properties, excellent shear stress characteristics and superior corrosion resistance

Characteristics
High resistance to weight ratio
Better sinking characteristics
Improved electrical properties
Excellent corrosion resistance

see data sheet
http://ww.nescoodisha.com/Technical_Specification_of_55S ....etc

[:=Read Full Message Here=:]

....etc

[:=Read Full Message Here=:]