This article describes the effect of tower displacement of two parallel transmission lines on the magnetic field distribution. Here, two parallel lines with the same working voltage and having the same span and in which the use of artificial tower displacement is made is modeled.Parallel transmission lines with different span lengths and different voltages produce tower displacements naturally and this is also modeled. Additionally, the effects like the spacing between the parallel lines, phase conductors arrangements and the transmission line ....etc

[:=Read Full Message Here=:]

SEISMIC ANALYSIS OF BRIDGES USING DISPLACEMENT-BASED APPROACH

By Chung C. Fu and Hamed AlAyed, University of Maryland

ABSTRACT
Nonlinear Static (Pushover) Procedure is specified in the guidelines for seismic rehabilitation of buildings presented by FEMA-273 (1997) as an analytical procedure that can be used in systematic rehabilitation of structures. However, those guidelines were presented to apply the Displacement Coefficient Method, which implements the well-known equal displacement rule with some modifications to esti ....etc

[:=Read Full Message Here=:]

i m just trying to do my project using bionic sensor.. so i need some information about it.. ....etc

[:=Read Full Message Here=:]

i would like to ask which displacement sensor can be used for identifying the shape made in air..??
how 3D displacement or capacitive sensors can be used for this purpose..?? ....etc

[:=Read Full Message Here=:]

An earthquake is vibration of earth surface by waves emerging from the source of disturbance in the earth by virtue of release of energy in the earth s crust. It is essentially a sudden and transient motion or series of motions of the earth surface originating in a limited under ground motion due to disturbance of the elastic equilibrium of the earth mass and spreading from there in all directions.

REASONS FOR HIGH CASUALITY:

1) Urbanization is rapidly increasing and due to increase in land cost, many multi storied buildings are being co ....etc

[:=Read Full Message Here=:]

Abstract:
This seminar is intended to evaluate the applicability of Nonlinear Static Procedure by implementing the Displacement Coefficient Method to bridges. For comparison purposes, the Nonlinear Dynamic Procedure (or nonlinear time-history analysis), which is considered to be the most accurate and reliable method of nonlinear seismic analysis, is also performed. A three-span bridge of 97.5 meters (320 ft) in total length was analyzed using both the Nonlinear Static Procedure/Displacement Coefficient Method and nonlinear time-history. Nine t ....etc

[:=Read Full Message Here=:]

Strength based and Displacement Based Design method for steel



Abstract

Performance based seismic design evaluates how a building is likely to perform for given earthquake loads. Seismic performance of a structure is closely associated with its strength, stiffness and ductility. In the present study structural strength and ductility mainly considered for the performance level for a steel moment resisting frame structure. The structure is analyzed according to Indian seismic code provision elastically un ....etc

[:=Read Full Message Here=:]

its a Multilevel Design Validation in a Secure Embedded Patient Monitoring System and its a method for measuring human gait (walking) posture using wearable sensors. Here The sensor used consist of a tri-axial acceleration sensor and three gyro sensors aligned on three axes. These are worn on the abdomen and the lower limb segments (both thighs, both shanks and both feet) to measure acceleration and angular velocity during walking. Three dimensional positions of each lower limb joint are calculated from segment lengths and joint angles. Segmen ....etc

[:=Read Full Message Here=:]

To get full information or details of patient fall detection using hip and abdomen sensor please have a look on the pages

http://seminarsprojects.net/Thread-patient-fall-using-hip-and-abdomen-sensor?pid=8865&mode=threaded

if you again feel trouble on patient fall detection using hip and abdomen sensor please reply in that page and ask specific fields in patient fall detection using hip and abdomen sensor ....etc

[:=Read Full Message Here=:]

To get full information or details of patient fall detection using hip and abdomen sensor please have a look on the pages

http://edutwint-patient-fall-using-hip-and-abdomen-sensor

if you again feel trouble on patient fall detection using hip and abdomen sensor please reply in that page and ask specific fields in patient fall detection using hip and abdomen sensor ....etc

[:=Read Full Message Here=:]