....etc

[:=Read Full Message Here=:]

its best if give this for free. WE WILL GLAD IF YOU GIVE FREE. AND SOON E WILL BE SUBSCRIBER IN YOUR WEBSITE.


:angel: ....etc

[:=Read Full Message Here=:]

details of design and fabrication of power clamping machine.
DETAILS OF DESIGN AND FABRICATION OF PWER CLAMPING MACHINE. ....etc

[:=Read Full Message Here=:]

hi i am doing a project on design and fabrication of pneumatic vice. kindly send me the design calculation for pneumatic vice.. ....etc

[:=Read Full Message Here=:]

1. Design of LCL-T Resonant Converter Including the Effect of Transformer Winding Capacitance
2. Design of High Voltage, High Power and High Frequency Transformer in LCC Resonant Converter
3. Analysis and design of a current-fed zero-voltage-switching and zero-current-switching CL-resonant push-pull dc-dc converter
4. Soft-Switching Capability Analysis of a Dual Active Bridge Dc-Dc Converter
5. Zero-Current-Transition Bridgeless PFC Without Extra Voltage and Current Stress
6. A Novel Soft Switching Fly back Converter with Synchronous Recti ....etc

[:=Read Full Message Here=:]

Introduction: Fluid power technology actually began in 1950 with the discovery of
Pascal's law: Pressure is transmitted undiminished in a confined body of fluid. Pascal
found that when he rammed a cork down into a jug completely full of wine, the bottom of
the jug broke and fell out. Pascal's law indicated that the pressures were equal at the top
and bottom of the jug. However, the jug has small opening area at the top and a large area
at the bottom. Thus, the bottom absorbs a greater force due to its larger area.
Combination of pneumatic ....etc

[:=Read Full Message Here=:]

fabrication of mini pneumatic vice in pdf

SYNOPSIS

In this project FABRICATION OF PNEUMATIC VICE we are using the pneumatic as pressing equipment; this will be useful in many applications. Like bending the metal rods, bearing fixing and pattern making etc Compressor is need to give the pressure for ON pneumatic.Here we are using one key, which act as a control switch for pneumatic. Microcontroller always check the key whether it is pressed or not, if the key is pressed, it will give a low pulse to the controller. When the controller recei ....etc

[:=Read Full Message Here=:]

The goal of this project is to create a model of bench vice which is pneumatically operated. Using air pressure to create mechanical motion in the spindle of the vice provides a safe & efficient way to reduce human effort.
The mechanical motion in the spindle is created with the help of a double actuating cylinder which is operated by a 5/2 pilot valve & two 3/2 push buttons with the help of the air hoses. ....etc

[:=Read Full Message Here=:]

Design and Fabrication of the Rotating &
Tilting Vice

ABSTRACT: In these modern days, the humans like to do all the works within a certain time with fast and effectively.
At the same time, the job should be fulfilling the requirement. The drawbacks of earlier system are overcome the
existing system. In the existing system, the radial drilling machine can be used to drill the fixed job with higher
efficiency. But it cannot rotate or tilt the job at particular angle. These drawback are overcomes by proposed system.
Design and fabrication ....etc

[:=Read Full Message Here=:]

design and fabrication of mechanical pipe vice

The goal of this project is to create a model of bench vice which is pneumatically operated. Using air pressure to create mechanical motion in the spindle of the vice provides a safe & efficient way to reduce human effort.
The mechanical motion in the spindle is created with the help of a double actuating cylinder which is operated by a 5/2 pilot valve & two 3/2 push buttons with the help of the air hoses. ....etc

[:=Read Full Message Here=:]