SYNOPSIS
An alternative configuration for a regenerative gas turbine engine cycle is presented that yields higher cycle efficiencies than either simple or conventional regenerative cycles operating under the same conditions. The essence of the scheme is to preheat compressor discharge air with high temperature combustion gases before the latter are fully expanded across the turbine. The efficiency is improved because air enters the compressor at a higher temperature, and hence heat addition in the combus ....etc

[:=Read Full Message Here=:]

to get information about the topic exhaust gas recirculation for gas turbine engines full report ppt and related topic refer the page link bellow

http://seminarsprojects.net/Thread-exhaust-gas-recirculation-full-report ....etc

[:=Read Full Message Here=:]

P V Ramaiah J. and G Krishnaiah2
I Department of Mechanical Engineering, Srikalahasteeswara Institute of Technology, Andhra Pradesh, India 2Department of Mechanical Engineering, SV University College of Engineering, Andhra Pradesh, India
The manuscript was received on 15 June 2006 and was accepted after revision for publication on 30 May 2007. DOl: 1O.1243/09544062JMES411


abstract

The paper deals with modelling and design of a friction damper. This has been done in four phases. In the first pha ....etc

[:=Read Full Message Here=:]

to get information about the topic Structural and thermal analysis of gas turbine casing ppt full report ,ppt and related topic refer the page link bellow
http://seminarsprojects.net/Thread-structural-and-thermal-analysis-of-gas-turbine-casing

http://seminarsprojects.net/Thread-structural-and-thermal-analysis-of-gas-turbine-casing?page=2

to get information about the topic Structural and thermal analysis of gas turbine casing ppt full report ,ppt and related topic refer the page link bellow
http://seminarsprojects.net/Thread-structural- ....etc

[:=Read Full Message Here=:]

Gas Turbine Technology
Introduction :
This article studies gas turbine technology and
determine whether this technology is applicable in the automotive industry. The gas turbine is viable source for rotational energy. Some applications include Jet Engine in a
Fighter-Jet, the Turbo-Prop Engine and the Turbofan Engine in commercial planes. the gas turbine engine by design
operates strictly with rotational energy. the gas turbine
engine is more thermodynamically efficient than the internal combustion piston engine. Today s ....etc

[:=Read Full Message Here=:]

to get information about the topic gas turbine full report refer the page link bellow

http://seminarsprojects.net/Thread-methods-of-improving-performance-of-the-gas-turbine ....etc

[:=Read Full Message Here=:]

Please provide the matter on high performance material used in stem and gas turbines. ....etc

[:=Read Full Message Here=:]

A gas turbine, also called a combustion turbine, is a type of internal combustion engine. It has an upstream rotating compressor coupled to a downstream turbine, and a combustion chamber in between.

The basic operation of the gas turbine is similar to that of the steam power plant except that air is used instead of water. Fresh atmospheric air flows through a compressor that brings it to higher pressure. Energy is then added by spraying fuel into the air and igniting it so the combustion generates a high-temperature flow. This high-temperatu ....etc

[:=Read Full Message Here=:]

pdf file on market survey on gas turbine and jet propulsion



Send a report on gas turbine and jet propulsion ....etc

[:=Read Full Message Here=:]

plz can any one help, i'm looking for gas turbine instrumentation.
thanks and best regards. ....etc

[:=Read Full Message Here=:]